Recommended Edge Evo HT Setting for Camper in Bed of 2000 Ram with 5.9 L Cummins Diesel

Question

Question:

I have an Edge EVO HT 36030 tuner. What setting should I use when I have my camper in the bed on my 2000 5.9L cummins diesel Ram?

asked by: Amanda

0

Expert Reply:

For your Edge Evo HT 36030, I recommend using the same setting as you would for any of the tuners when hauling a load. I recommend using the "Tow" setting for light load tow.

expert reply by: Jason S

0

Answer 1

I have a solution for you, but the Edge Module part #EZD1000A is not a fit for the 2005 Dodge Ram Cummins. Instead you would want the #EP36040 if you have the 325 horsepower Cummins or the part #EP30204 for if you have the Common Rail 24 valve that…

view full answer...

Answer 2

Your Edge EvoHT2 #EP36040 is also a confirmed fit for your 2001 Dodge Cummins. This controller is only able to be used on one vehicle at a time, so setting that tuned vehicle back to stock will allow it to be used on another vehicle. Since he said he…

view full answer...

Answer 3

I checked out the installation instructions for the EvoHT2 Tuner, part #EP36040 and found that on page 18 it is explained how to return the engine tuning to stock. From the main menu you will need to select 'Tune Vehicle'. Then select…

view full answer...

Answer 4

Superchips and Edge are actually made by the same company so the tunes you'll get between the two will yield the same power gains. The advantage to the Superchips like the part #SU4845 is that you aren't paying for additional features like a…

view full answer...

Answer 5

Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…

view full answer...

Answer 6

Hey Jeff. There is definitely a correlation between weight and capacity. I've listed the weight of all three of the Power Mountain Tallboy Off-Road Bottle Jacks we have below: Power Mountain Tallboy Off-Road Bottle Jack - 7-15/16" to…

view full answer...

Answer 7

Yes, it will work. You'll just need to cut the Lance 6-pin connector out and rewire it into the etrailer Trailer Wiring 7-Way Upgrade Kit w/ Junction Box and RV Style Connector item #e99011. Here are the individual functions of that Lance 6-pin:…

view full answer...

Answer 8

Hey Ian, great to hear from you again! The differences between the MORryde CRE3000 #MR87ZR and AllTrek 4000 #MR89DR that fit a 33" wheelbase is the height between the hanger and equalizer bolts, and the amount of travel the suspension style will…

view full answer...

Answer 9

Hi Paul, you’re definitely on the right track here, and I can help you narrow this down with confidence. With your tandem 3,500 lb Dexter axles and 33 inch spacing, both the Dexter EZ Flex part #K71-652-00 and the Lippert Road Armor part #LC53CK are…

view full answer...

Answer 10

Hey Melanie. The reason you can't find a replacement for your GE ARC15AACBL2 15,000 btu air conditioner is because they phased them out. In 2025 all RV AC systems had to change over to a new coolant called R32. This was a EPA mandated decision.…

view full answer...

Answer 11

Hey Kyle! The Pacbrake Alpha HD Air Bag Suspension Kit #PB22RV installs in the same location as most fifth wheel and gooseneck brackets. I would expect to have to do some drilling to install these with your B&W Turnoverball. Instead, I recommend…

view full answer...

Answer 12

Hello Bob, thanks for reaching out. We do have a lock that will work with the etrailer Adjustable 2-Ball Mount #e66PR. For that I recommend the following: - etrailer Hitch Receiver Lock for 2" and 2-1/2" Hitches - Flush - 3-5/8" Span -…

view full answer...

Recommended Edge Evo HT Setting for Camper in Bed of 2000 Ram with 5.9 L Cummins Diesel

Product Page this Question was Asked From

Continue Researching