How To Reset Edge EvoHT2 Hand-Held Performance Tuner
Updated 07/30/2020 | Published 03/04/2017
Question:
how do I reset this product?
asked by: Romeo E
Expert Reply:
I checked out the installation instructions for the EvoHT2 Tuner, part # EP36040 and found that on page 18 it is explained how to return the engine tuning to stock.
From the main menu you will need to select 'Tune Vehicle'. Then select 'Quick Tune'. Then turn the ignition on but do not start the engine. You then press enter. Next, you select 'Stock' from the Tune Vehicle screen. When it asks if you wish to return the vehicle to stock you select Yes. Then turn the ignition switch off and remove the key, and press enter. At this point the vehicle has been returned to the stock setting.
I have attached a copy of page 18 of the instructions you can check out.
Product Page this Question was Asked From
Edge EvoHT2 Hand-Held Performance Tuner - Dodge/Ram - Gas/Diesel
- Performance Chip
- Performance Tuners
- Tuner Only
- Color Screen
- No - Not California Approved
- EvoHT2
- Edge
more information >
Continue Researching
- Shop: Performance Chip Tuners
- Shop: Edge EvoHT2 Hand-Held Performance Tuner - Dodge/Ram - Gas/Diesel
- Search Results: performance chip tuners
- Q&A: Recommended Edge Evo HT Setting for Camper in Bed of 2000 Ram with 5.9 L Cummins Diesel
- Shop: Superchips' Flashcal Handheld Tuner - Ford F-Series Trucks - Tire & Gear Calibration
- Shop: Edge EvoHT2 Hand-Held Performance Tuner - California Approved - Gas/Diesel
- Shop: Superchips Flashpaq F5 Performance Tuner - Dodge/Ram - Gas/Diesel
- Search Results: performance tuners performance chip
- Q&A: Edge EvoHT2 Tuner for 2001 Dodge Cummins Compatibility
- Q&A: Edge Programmer Recommendation for a 2005 Dodge Ram Cummins
- Shop: Edge EZ for Dodge Cummins 5.9L, 24V
- Shop: Edge Insight CS2 Comprehensive Gauge Display - Color Screen
- Shop: Superchips Flashcal Calibrator for Dodge/Ram Truck
- Q&A: Which Gives More Power an Edge Programmer or a Superchips Programmer For 2009 Dodge Ram 1500
- Q&A: Can an Edge Programmer be Reset if it is Installed on a Vehicle
- Q&A: Replacement For 12,000 lb Drop Leg Jack
- Q&A: Can the Titan Aero 6000 Surge Brake Actuator Be Repaired Or Should It Just Be Replaced
Ed
7/30/2020
He didn't ask how to set vehicle back to stock. He asked how to fresh the tuner back to stock, including passwords etc. Duh.