Parts Needed to Install Optronics LED Lights on Custom Bumper on 2012 Toyota Tacoma

Updated 08/21/2017 | Published 08/18/2017

Products Featured in This Question

Optronics LED Trailer Light - Brake, Tail, Turn - Submersible - Oval - Red

(1811)

$13.21

22-18 Gauge Butt Connectors - 5 Pack

(16)

$4.02

3-Wire Pigtail for Optronics Trailer Lights - 3-Prong PL-3 Plug - 10" Lead

(397)

$5.20

Right Angle 3-Wire Pigtail for Optronics Trailer Lights - 3-Prong PL-3 Plug - 10" Lead

(694)

$8.70

Loctite Bulb, Lamp, and Electrical Connection Dielectric Grease - 0.33-Oz Tube

(138)

$9.07

Optronics LED Trailer Tail Light - Stop, Turn, Tail - Submersible - 10 Diodes - Round - Red Lens

(2265)

$17.13

Question:

I have a 2012 Toyota Tacoma 4WD, 4 door, TRD Sport, 6cyn, long bed. I just had a custom rear bumper installed and now my tail lights are being blocked. I am looking at installing Item # STL72RB or Item # STL42RB in the bumper. Is there a wiring harness or adapter that I can plug into my current tail lights to easily wire up one of these two parts?

asked by: Ben B

Expert Reply:

Both of the Optronics LED stop/turn/tail lights you referenced, parts # STL72RB and # STL42RB, use a 3-prong connector, either straight plug # A45PB or right-angle plug # A47PB. These fit the receptacles on the back of the light housings and provide 10-inch pigtails leads for connection.

For a plug-n-play 4-pole harness to power the lights you can use the Tekonsha kit # 118496 which connects at the Tacoma's taillights with custom-fit connectors. You'll then cut off the 4-pole plug and use butt connectors # 05730-5 and dielectric grease # LT37534 to ensure a clean reliable connection.