Adjusting Husky Center Line Weight Distribution System For More Level Ride And Sway Control
Updated 06/27/2017 | Published 06/26/2017
Question:
Hi I was wondering, when the dealer did our hitch system up and after I got home I noticed that the bars are not level with the trailer frame . They taper down towards the trailer. From what I can see everywhere they say level. Seems to ride okay other than in a big wind. Truck is F250 4x4 6.2 gas and trailer is 36 ft overall at approx 10000 loaded. Thank you
asked by: Wayne C
Helpful Expert Reply:
The Husky Center Line Weight Distribution w/ Sway Control - Trunnion - 12,000 lbs GTW, 1,200 lbs TW # HT32218 may not have the bars level with the frame based on the bracket height needed to optimize the ride of your trailer. If you want to add more tension for the big wind and thus increased sway, you can raise those brackets to add more resistance to the trunnion bars. The other adjustment you can make is in the tilt of the hitch head by adding or removing washers. This adjustment will change the angle of your system. I've attached videos to assist as well as installation instructions.
Featured Help Information
Miscellaneous Media
Continue Researching
- Search Results: fifth wheel hitch
- Shop: Suspension Enhancement
- Shop: Air Lift LoadLifter 5000 Air Helper Springs - Rear Axle
- Search Results: air lift compressor
- Shop: Air Lift WirelessONE Compressor System for Air Helper Springs - Remote - Bluetooth - EZ Mount
- Shop: Firestone Ride-Rite Air Helper Springs - Double Convoluted - Rear Axle
- Q&A: Husky Weight Distribution Hitch Adjustment
- Video: Review of Thetford Replacement Water Module Assembly - TH64UE
- Article: How to Install a Weight Distribution Hitch (With Pictures & Video)
- Search Results: eaz lift
- Shop: Replacement Water Module Assembly for Thetford Aqua-Magic V and Aqua-Magic VI RV Toilets
- Video: Curt Weight Distribution Head Angle Adjustment: The Breakdown
- Q&A: Is Lubricating a Husky Weight Distribution System a Solution for Noise
- Shop: Curt Round Bar Weight Distribution System w/ Friction Sway Control - 10K GTW, 1K TW
- Shop: Curt Head Angle Adjustment Kit - For Trunnion-Style WD Hitches - Bolt, Washers, Clip - 1,500 lbs TW
- Q&A: Adjusting Head Of Husky Center Line Weight Distribution Hitch To Level Spring Bars
- Q&A: 2 1/2 Shank Recommendation for Use with the Husky Center Line HT32218 WD System
- Q&A: Adjusting the Angle of the Head on an EAZ Lift Weight Distribution System
- Q&A: Troubleshooting Weight Distribution Hitch Setup And Transferring Additional Weight To Front Axle
- Shop: Firestone Ride-Rite Air Helper Springs - Double Convoluted - Rear Axle
- Shop: Trailer Hitch
- Article: Trailer Wiring Diagrams
- Search Results: trailer hitch
- Q&A: What is the Difference Between a Class II and a Class III Hitch?
- Shop: Trailer Wiring
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Search Results: trailer wiring
- Article: How to Measure for Trailer Hitch Drop
- Search Results: trailer tires and wheels
- Shop: Brake Controller
on Weight Distribution Hitch
