Can Blaylock EZ Jack be Used on Trailer with Leaf Springs

Question

Question:

Will this jack work with a 5th wheel RV using Leaf Springs. Most product like this will only work with torsion suspension system. Thanks

asked by: Richard W

0

Expert Reply:

The Blaylock EZ Jack and Wheel Chock for Tandem-Axle Trailers # EZ-JACK can fit trailers with leaf springs.

If you check out the picture I attached you can see it used on a leaf spring trailer just like yours.

expert reply by: Jameson C

0

click to enlarge

Mike M.

3/8/2020

With the Blaylock EZ Jack has anybody try changing a flat tire on a tandem axle with leaf spring? Would like to known if the flat tire clears the ground?

Chris R.

3/10/2020

We've actually had quite a few customers use these to change a flat tire on a dual axle trailer when needed. If you check out the picture Jameson posted above you can see that the rear tire clears the ground with plenty of room to remove it.

Answer 1

Hey Mitchell, yes the Valterra StayPut Tandem Trailer Tire Changing Ramp #VAL68MB that you referenced will work with the Curt independent suspension you have and will still lift the trailer wheels up high enough to allow you to change it. How do you…

view full answer...

Answer 2

Hey Mac! If you're using 2x4's the tallest option I have for you is the Ultra-Fab Leveling Blocks item #UF48-979052 that you were looking at. They're 1-3/8" tall and you're going to be limited to stacking them five high. This…

view full answer...

Answer 3

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 4

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 5

Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…

view full answer...

Answer 6

Hi Paul, you’re definitely on the right track here, and I can help you narrow this down with confidence. With your tandem 3,500 lb Dexter axles and 33 inch spacing, both the Dexter EZ Flex part #K71-652-00 and the Lippert Road Armor part #LC53CK are…

view full answer...

Answer 7

To install a Redarc Tow Pro Liberty in your 2023 Toyota Tacoma Sport you will need the following parts: Redarc Tow-Pro Liberty Brake Controller item #RED24FR Plug-and-Play Wiring Harness for Redarc Tow-Pro Trailer Brake Controllers item #RED99FR…

view full answer...

Answer 8

Hey Melanie. The reason you can't find a replacement for your GE ARC15AACBL2 15,000 btu air conditioner is because they phased them out. In 2025 all RV AC systems had to change over to a new coolant called R32. This was a EPA mandated decision.…

view full answer...

Answer 9

Even though I cannot comment specifically on the grease you used because I am not familiar with it, I can tell you the best grease for trailer bearings is a a grease with a rating of GC-LB, which just means it is made to withstand very high…

view full answer...

Answer 10

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 11

That's a very good question, we tend to be extra cautious and say to use 10 gauge wire because that would be more than enough. When you get into longer trailers that will end up using a lot of wire the heavier gauge wire becomes more necessary.…

view full answer...

Answer 12

Hello Martin, Great question. The Aqua-Magic VI #TH37SE uses the same standard 2-bolt pattern and seal style as the Aqua Magic IV. So from a bolting-it-down standpoint, they’re compatible. The only thing you really need to double-check is the space…

view full answer...

Can Blaylock EZ Jack be Used on Trailer with Leaf Springs

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching