What Is Distance From Mounting Plate To Top Of Motor Housing On Ultra-Fab Electric A-Frame Jack
Updated 06/15/2017 | Published 06/13/2017
Question:
Im replacing the jack on my hybrid trailer. Since theres a front bunk, this cannot be too tall of the bunk end will not open properly. What is the height of this jack from the mounting bracket to the top of the motor housing?
asked by: Greg S
1
Helpful Expert Reply:
The distance from the top of the motor housing down to the mounting plate for the Ultra-Fab Electric A-Frame Jack # UF38-944014 is 18 inches. I have attached a photo of the jack that shows the measurement you asked about.
expert reply by:
Jeffrey L
1
click to enlarge
Product Page this Question was Asked From
Ultra-Fab Electric A-Frame Jack w/ 2-1/4" Tubing - Drop Leg - 22-1/2" Lift - 4,000 lbs
- Camper Jacks
- Pop Up Camper
- Teardrop Camper
- Travel Trailer
- A-Frame Jacks
- Steel
- 3001 - 4000 lbs
- Electric Jack
- 22-1/2 Inch Lift
- Bolt-On
- Weld-On
- 1 Jack
- Ultra-Fab Products
more information >
Continue Researching
- Q&A: Does Ventline E-Z Lift Ventadome Trailer Roof Vent # V3092-603-00 Have Ceiling Garnish
- Q&A: Will a 3,500 Pound Capacity Electric Jack Work Well on 7,500 Pound Travel Trailer
- Q&A: Replacement Parts for the Bulldog Powered Drive Trailer Jack part BD500199
- Q&A: Upgrading Discontinued Lippert Trailer Jack 181794
- Q&A: What is the Difference Between Bulldog Jacks # BD500199 and BD500200
- Q&A: Troubleshooting Husky Brute Trailer Jack Not Working
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Q&A: Recommended Electric Trailer Jack For A 2018 Jayco Whitehawk
- Article: The Best Electric Trailer Jacks of 2025
- Article: Gooseneck to 5th Wheel Adapters
- Article: Guide to Choosing the Best Truck for 5th-Wheel Towing
- Article: Gooseneck Trailer Hitch Information and Review
- Article: Trailer Wiring Diagrams
- Article: How to Tell the Weight Rating of a Trailer Axle