Pal Nut Removal Instructions
Updated 08/08/2025 | Published 06/07/2017
Question:
Is there a special tool to remove pal nuts? I currently have these on my trailer and cannot get them off to to replace them and a new roller....,Thanks, Jeff
asked by: Jeffrey F
0
Expert Reply:
The cap and roller are held onto the shaft by a pal nut. The best way to remove the pal nut is to grab it with a pair of pliers and rock it back and forth until the pal nut deforms enough to pull off the end of the shaft. A pal nut is a one-time use product.
Replacement 1/2 inch pal nuts are available as part # CE10800.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Replacement Cap Nut - Zinc - 1/2" - Qty. 1
- Accessories and Parts
- Boat Trailer Parts
- Hardware
- 1/2 Inch Diameter
- Nuts
- Cap Nut
- CE Smith
more information >
Continue Researching
- Search Results: roller shaft
- Search Results: trailer leaf springs
- Shop: Nylon Bushing - 9/16" Inner Diameter, 1.024" Outer Diameter - 1-3/4" Long
- Shop: Roller Shaft with Cap Nuts for Boat Trailer Rollers - Zinc-Plated Steel - 13" x 5/8"
- Video: Ultimate Overview of the Leaf Spring Bushing
- Video: Let’s Check Out the 4-Leaf Slipper Spring w/ Open Eye End for 4,300-lb Trailer Axles
- Video: Nylon Bushing Review
- Video: Ultimate Overview of the CE Smith U-Bolt Kit for Mounting 1-1/2" Square Trailer Axles
- Shop: CE Smith Roller Shaft for Boat Trailers - Zinc-Plated Steel - 11" x 5/8" - Qty 1
- Shop: 4-Leaf Slipper Spring w/ Open Eye End for 4,300-lb Trailer Axles - 26-1/4" Long
- Shop: etrailer Rust-Resistant 4-Leaf Slipper Spring for 4,300-lb Trailer Axles - 26-1/4" - Dacromet
- Shop: Leaf Spring Bushing - Bronze - 1.74" Long x 0.70" OD x 0.58" ID - Qty 1
- Shop: Roller Shaft with Cap Nuts for Boat Trailer Rollers - Zinc-Plated Steel - 12-3/4" x 1/2"
- Video: The Low-Down on the Yates Keel Roller for Boat Trailers
- Q&A: How Do Pal Nuts Remove from Roller Shafts
- Video: Detailed Breakdown of the Yates Keel Roller for Boat Trailers
- Q&A: How to Remove A Pal Nut
- Q&A: How to Install Pal Nuts on a Roller Shaft
- Search Results: 5/8 roller shaft
- Article: Replacing the Bearing, Races and Seals on a Trailer Hub
- Article: Trailer Wiring Diagrams
- Search Results: yates rubber boat trailer parts
- Q&A: Brake Controller Install on 1997 Chevrolet Pickup
- Q&A: Recommended Guide to Center 1850 Lund Impact on Shorelander Boat Trailer
- Q&A: Interior Dimensions of the UWS Cargo Carrier for 2" Hitches
- Q&A: How to Determine What Size Wobble Rollers are Needed to Replace Boat Trailer Rollers
Ole H.
8/7/2025
Well, tried vise-grips locked on caps at both ends, they simply slipped. Next, clamped assembly to work bench, drilled hole and used punch; no joy. Lastly; angle grinder. Bingo! :)