Can Built-In Camber be Adjusted on Timbren Axle-Less Trailer Suspension System with Hubs
Updated 06/05/2017 | Published 06/02/2017
Question:
Can the caster be adjusted for toe-in etc as they wear?
asked by: Chris
Expert Reply:
When installing the Timbren Axle-Less Trailer Suspension System with Hubs # A12WS545 referenced in your question, the toe-in will need to be set. However, the system does include shims that will allow you to adjust the camber as needed. I have attached an installation video on this product for you to check out. Right around the 4 minute mark you can see this feature explained.
This is a great axle-less suspension system with a weight capacity of 1,200 pounds and a bolt pattern of 5 on 4-1/2 inches. The hubs will include the # L44610 inner and outer bearings, as well as the races and seals.
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: What is the Maximum Length for a Propane Hose
- Shop: Suspension Enhancement
- Video: Complete Breakdown of the Timbren Axle-Less Trailer Suspension w/ Idler Hubs
- Search Results: timbren
- Shop: MB Sturgis Propane Hose - 3/8" Male NPT x 3/8" Female Flare Swivel - 4'
- Video: DIY 2011 Chevrolet Suburban Installation for the Timbren Rear Suspension Enhancement System
- Shop: Timbren Rear Suspension Enhancement System
- Shop: MB Sturgis Propane Extension Hose - Dual Type 1 Tank Valve - 15'
- Shop: Propane T-Fitting for Type 1 Valve - Disposable Cylinder Ports
- Shop: MB Sturgis Propane Extension Hose - Dual Type 1 Tank Valve - 20'
- Shop: MB Sturgis Type 1 Propane Tank Connector - 450,000 BTU
- Video: MB Sturgis Propane Hose Review
- Video: Best 2013 Chevrolet Suburban Suspension Enhancement Options
- Video: Set up: Timbren Rear Suspension Enhancement System on a 2005 Chevrolet Suburban
- Shop: Propane Hose - 3/8" Female SAE Flare Swivel x 3/8" Female SAE Flare Swivel
- Search Results: compression latch
- Search Results: lock n roll
- Article: How Level Should a Tow Bar Be When Flat Towing