Salt Spray Rating of etrailer.com Square Trailer Jack

Question

Question:

Interested in jack #MJSQ-2500B. Can you tell me its salt spray rating? Thank you

asked by: Jim H

0

Expert Reply:

The salt spray rating of jack # MJSQ-2500B is 100 hours.

expert reply by: Charles S

0

Answer 1

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 2

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 3

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 4

I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and non-ABS…

view full answer...

Answer 5

Hey Sean, yes you can definitely use a stand alone system like a single-acting hydraulic pump to power a hydraulic trailer jack like the single action Stillwell lineup we just started carrying. For the Stillwell Atlas IV 10K Hydraulic Trailer Jack w/…

view full answer...

Answer 6

Hey Will, thanks for reaching out. What I recommend for replacing your 7-way is the following: - etrailer Trailer Wiring 7-Way Upgrade Kit w/ Junction Box and RV Style Connector #e99011 Wiring your connections thru the junction box helps keep them…

view full answer...

Answer 7

Hey Uriah, thanks for reaching out! The Tradesman Vaquero Self-Contained Hydraulic A-Frame Trailer Jack #ST86FR will work best if it's hardwired to a battery on your trailer, but you can also hardwire a 7-Way plug and lead like part #H20043 and…

view full answer...

Answer 8

Hey Marc, if you have the ability to apply the brakes with the manual override lever lots of times while moving slowly before needing to go on a trip then yes you can just install the brakes and not worry about an initial adjustment. It may take some…

view full answer...

Answer 9

I do have some great jack options for you and your boat but the jack does not need to be rated for the entire weight of the boat, at least directly. For example, a trailer jack rated at 2,500 lbs is more than enough for a 12,000 lb boat. The reason…

view full answer...

Answer 10

Hey Jeff, The specs you are looking for on that B & W tongue weight scale, #BW34KR, are below. Since this is a brand new item from B & W there is no earlier date to get this yet as it is set to release fall of 2025. The over all capacity of…

view full answer...

Answer 11

Fulton Square Drop Leg for Stabilizer Jack, 29" Long Item #FSJ20324 by itself will be 24-3/4 inches tall from where it attaches to the jack to the bottom of the foot with the drop leg in the tallest position. It is essentially more than doubling…

view full answer...

Answer 12

There are a few solutions for your tailgate to clear the jack on your trailer. I recommend to use a longer ball mount like #D-26, that would move the trailer back further away from the truck and give you clearance you need. If you know what size the…

view full answer...