How to Unplug Harness of Prodigy P2 Brake Controller # 90885

Question

Question:

back of the controller tried both end now Ithink I damaged where it goes in under the dash im so sad.Why wont itcome outis there a safety mechanism or something. So frustrated. Im messing my trucks tow package up.

asked by: Pam

0

Expert Reply:

I attached a picture that points out where the release tab is for the harness that plugs into the Prodigy P2 part # 90885 that you have. You have to pull up on it so that the harness will separate.

expert reply by: Jameson C

0

click to enlarge

Dean

7/29/2024

I have a DX3 Motor coach it has the prodigy P2. I know by the display o.9 I have a ground problem. I looked around the battery area and saw no white wire went to the area of my seven way and nothing resembled the white wire from the Prodigy P2. Lots of white wires. Need a service call?

Jameson C.

7/29/2024

@Dean There really should be a white wire coming from your P2 that goes to a solid ground that could be the negative post of the battery. So you are going to have to check the wires that come from the P2 and find that white wire and see what it is attached to and trace it back to where it is attached and improve that.

Answer 1

Hey Bob, we have just what you are looking for with the Replacement Color Touchscreen Display for the TST TPMS 770 Series part #TST64VR. How do you like the 770 Series?

view full answer...

Answer 2

To remove the Tekonsha Prodigy P2 #90885 you simply need to detach the harness at the rear of the brake controller. Once that is removed you can tuck the harness up under your dash with some zip ties andthe uninstall the bracket that holds the brake…

view full answer...

Answer 3

To disconnect the Prodigy P2 Brake Controller #90885 you simply locate where the wiring harness inserts into the back of the controller and unplug it. To uninstall the bracket you just take the screws out and remove the bracket.

view full answer...

Answer 4

The easiest way to disconnect your trailer brake controller from your vehicle is to disconnect your brake controller. You'll just need to unplug the controller plug from the back of the brake controller. This should eliminate any power draw from…

view full answer...

Answer 5

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 6

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 7

Hey Jonathon thank you so much for all of that additional information! To haul your bikes behind your class C Sprinter motorhome, while flat towing your Mini, I recommend the Hollywood Racks RV Rider Bike Rack item #HLY64FR and the Roadmaster Dual…

view full answer...

Answer 8

Hello again Brett, Congrats on the new truck! I am pretty sure that the connector on the back of your 2024 Ram 1500 Classic is a 7-way connector, you are supposed to count all the slots and include the piece in the middle. I attached some pictures…

view full answer...

How to Unplug Harness of Prodigy P2 Brake Controller # 90885

Continue Researching