Can E-Track Sections be Cut with a Saw
Published 12/15/2016
Question:
Hi, Can I cut a piece of E-track with a hack saw or saber saw? I want to buy 5-foot sections, knowing I will likely have to cut off a little. Please advise. Thanks,
asked by: Bill K
0
Expert Reply:
As long as your saw is capable of cutting steel there's no reason you couldn't cut a section like the part # E19148 that you referenced.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Erickson Horizontal E Track - Zinc Plated Steel - 2,000 lbs - 5' Long - Qty 1
- E Track
- E Track Rails
- Horizontal
- 5-1/8 Inch Wide
- 2000 lbs
- 5 Feet Long
- Erickson
more information >
Continue Researching
- Shop: Self-Drilling Screw Hardware for Snap-Loc E-Track Tie-Down Anchors - Qty 4
- Q&A: Attaching E-Track to Wooden Trailer Floor
- Q&A: Mounting Suggestion For E-track To Aluminum Utility Trailer
- Q&A: Are There Long-Term Service Contracts To Use PingMaster Trailer Tracking Devices?
- Q&A: How Many Additional Panels Can Be Added To The Rich Solar RV Solar Charging Kit RS37VR
- Q&A: Is E-track Stronger Than X-track, Is There An Advantage Of One Over The Other
- Article: How to Install E-Track in 3 Easy Steps
- Q&A: Differences Between Different Brands of E-Track
- Q&A: Do All 4 UTV Wheels Need to be Strapped Down with Erickson ATV E-Track Tie-Down Kit # EM09160
- Article: How to Measure Your Trailer Wheel Bolt Pattern
- Article: Printable Trailer Bolt Hole Pattern Template
- Article: Towing a Trailer? Let's Talk About Brake Controllers
- Article: Hand Winches
- Article: The Best Trailer Tongue Locks for Preventing Trailer Theft
- Article: Trailer Wiring Diagrams