Where to Measure to Determine if Span of Hitch Lock 2866DAT Is Long Enough
Published 11/07/2016
Question:
I have a bruan mobility lift that has a 1/2 inch pin hole on a 2 inch receiver but most all the 1/2 inch pins come up short for locking as my receiver hitch is 2 inches will this locks half inch pin go all the way through and lock on a 2 inch receiver.
asked by: Jerry
0
Expert Reply:
The usable span of the # 2866DAT that you referenced is 2-3/4 inches. You would need to measure the width of your hitch to know if that would be enough. Most likely it would be pretty close.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Swivel Head Trailer Hitch Receiver Lock for 1-1/4" and 2" Trailer Hitches
- Trailer Hitch Lock
- Standard Pin Lock
- Keyed Unique
- Stainless Steel
- Fits 1-1/4 and 2 Inch Hitch
- Fits 1-1/4 Inch Hitch
- Fits 2 Inch Hitch
- Bent Pin
- 2-3/4 Inch Span
- Master Lock
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: Leveling Blocks to Replace Stromberg Carlson Base Pad
- Q&A: How to Find the Right Weight Distribution System for Trailers With 2,900 lb and 5,200 lb Dry Weight
- Q&A: Does The Bumper Need To Be Cut To Install a Trailer Hitch Receiver on a 2022 Honda Civic Hatchback?
- Q&A: Does Trailer Hitch for 2018 Honda Civic Coupe Require Rear Bumper Trimming
- Q&A: Why Does Bumper Beam of 2019 Honda Civic Need to be Trimmed to Install Curt Trailer Hitch
- Q&A: Is There a Replacement Hub For a AL-KO 7170 Trailer Hub?
- Q&A: Correct Replacement for AL-KO 568182 or Hayes 09089324
- Article: Is It Illegal to Leave My Hitch on My Truck?
- Article: The 5 Best Trailer Drop Hitches You Can Buy
- Article: How to Measure for Trailer Hitch Drop
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)
- Article: Trailer Maintenance Schedule
- Article: Trailer Wiring Diagrams
- Article: My Trailer Hitch Doesn't Fit