Will the etrailer Round, Snap-Ring Swivel Jack # TJBB-2001-B Fit on a 2 inch by 5 inch Trailer Frame
Published 10/25/2010
Products Featured in This Question
Question:
Only one more question. Please let me know the retracted dimension from the center of the mounting bracket to the bottom of wheel. I only have 12 inches max.
asked by: Joe V
Expert Reply:
We have several options for a bolt on swivel jack for your trailer with 2 by 5 inch frame (see link). I would recommend the Pull Pin, Easy Swivel Trailer Jack with 8 inch Wheel - Sidewind - 1,500 lbs. by Dutton-Lainson, item # DL22800, for your trailer if the 1500 pound capacity is sufficient for your boat and trailer. These jacks are high quality and designed to fit square tongues up to 3 x 5 inches.
The etrailer Round, Snap-Ring Swivel Jack - Bolt On - Topwind - 10 1/2 inch Lift - 2,000 lbs, item # TJBB-2001-B, is not designed to fit on frames higher than 4 inches tall. At this time we do not have a swing up jack for 5 inch tall frame that has a 2,000 pound capacity.
Product Page this Question was Asked From
Round Snap Ring Swivel Jack w/ Footplate - Bolt On - Black - Topwind - 10-1/2" Travel - 2K
- Trailer Jack
- Enclosed Trailer
- Utility Trailer
- Side-Mount Jacks
- Swivel Jacks
- Standard Grade
- 1001 - 2000 lbs
- Manual Jack
- 10 Inch Lift
- Bolt-On
- With Rectangle Foot
- etrailer
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Article: Testing Trailer Brake Magnets for Proper Function
- Q&A: Mounting Bracket Hole Spacing on etrailer Round Snap Ring Swivel Jack TJBB-2001-B
- Q&A: Replacement Converter For Parallax 7300 Series
- Q&A: Can You Replace The Factory Hitch Receiver On A 2004 Toyota Tundra.
- Q&A: Replacing Factory Hitch on 2006 Toyota Tundra
- Q&A: What Is The Max PSI Rating For The Aluminum Eagle Trailer Wheel LH48VR?
- Article: 5 Things to Know About Weight Distribution Hitches
- Article: 5 Tips to Confidently Choose Your Weight Distribution Hitch
- Article: How to Install E-Track in 3 Easy Steps
- Q&A: Recommended Replacement Jack for Exiss Horse Trailer
- Q&A: Trailer Jack to Avoid Tailgate Clearance Issues
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Breakaway Kit Installation for Single and Dual Brake Axle Trailers
- Article: Trailer Jacks
Joe
10/25/2010
Only one more question. Please let me know the retracted dimension from the center of the mounting bracket to the bottom of wheel. I only have 12 inches max.