Recommended Parts To Convert Hydraulic Drum To Disc Brakes On EZ-Loader Trailer

Updated 08/03/2016 | Published 08/02/2016

Products Featured in This Question

Kodiak Disc Brake Kit - 10" Hub/Rotor - 5 on 4-1/2 - Dacromet - 3,500 lbs

(93)

$563.90

Trailer Wheel Bearing Kit for Lippert, Dexter, and AL-KO Axles - 3,500 lb with #84 Spindle

(3079)

$19.79

Question:

I have a boat trailer EZ loader model #TE2L 102B 17-20/22 4000 Serial #1ZEAAZRT2DA000582. Trailer capacity 400lb, oil bath bearing system. Coupler Triler Buddy model A-60/A-75 hydronic actuator. Spindle size ? This is the bearing inner #250-031477, outer #250-031474 and seal #350-031468. Wheels and tires 13foot rims, 175/80/13 can I keep these wheels with a disk brake system. Let me know if you require more information to recommend all parts required to convert a drum brake system to a disk brake system.

asked by: Jean-Guy

Expert Reply:

In my research I found that the numbers you mentioned for the bearings you have on your trailer match a bearing kit we offer. The kit for one wheel is part # BK2-100. This is designed for a 3500-lb axle. The kit includes inner and outer bearings, race, seal, washer and cotter pin.

The disc brake kit I recommend is the Kodiak Kit, part # K2HR35D. The wheel size this kit will work with is 13 inches or bigger. The hub/rotor included with this kit has a 5 on 4-1/2 bolt pattern for the wheels so you will want to make sure the bolt pattern for your wheels is the right pattern. I have attached a helpful article that explains how to measure the bolt pattern of your wheels.

A coupler designed for drum brakes usually has a 1000 psi rating where a disc brake actuator has a rating of 1,500 or 1,600 psi. You may be able to just replace the master cylinder to a higher rated one that can work with disc brakes. We do not offer a master cylinder designed for your actuator.

expert reply by: Jeffrey L