Will an Ultra Fab Landing Gear fit a Trailer that has an Atwood Set Currently Installed
Updated 04/22/2016 | Published 04/20/2016
Question:
are the tabs for a atwood landing gear not in the correct spots to mount the ultra fab without having to weld new ones in?
asked by: Cory
0
Expert Reply:
Ultra Fab landing gear like the # UF17-943010 use a larger dimension for the mounting tabs than the Atwood. Lippert, Venture, and Atwood landing gear, as well as those from a few other manufacturers use 17-1/2 inches but Ultra Fab uses 20-1/4.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Ultra-Fab Deluxe Electric Landing Gear Set - Weld On - 38" Lift - 12,000 lbs
- Camper Jacks
- 5th Wheel Camper
- Landing Gear
- Steel
- 10001 lbs or More
- Electric Jack
- 38 Inch Lift
- Weld-On
- 2 Jacks
- Ultra-Fab Products
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: Dual Electric Jacks for 24,000 lb Gooseneck Trailer
- Q&A: Comparing the Reese # RP500708 and Ultra-Fab Deluxe # UF17-943010 Landing Gear
- Q&A: How to Choose the Correct Replacement Landing Gear for 5th Wheel Trailer
- Q&A: Best Landing Gear Upgrade Options for 5th Wheel Trailer
- Q&A: How To Choose The Correct Replacement Landing Gears For A 2021 Cherokee Wolfpack 365pack16
- Q&A: Can Curt Flex Air 5th Wheel Pin Box Be Used With Andersen Ultimate Hitch?
- Q&A: How to Pull a Gooseneck Trailer w/a 2020 Peterbilt 567 Tractor
- Article: 4 Steps to Choosing Your 5th Wheel Pin Box
- Article: Trailer Wiring Diagrams
- Article: The Best Electric Trailer Jacks of 2025
- Article: Ram Trailer Tow Prep Package
- Article: Brake Controller Installation: Starting from Scratch
- Article: Best Landing Gear
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)