Replacement Magnet Clip and Spring for 12 Inch Electric Trailer Brake Assemblies
Updated 04/19/2016 | Published 04/17/2016
Products Featured in This Question
Question:
I would like to know if I can buy some extra clips and springs for the brake magnets. I have one magnet that is still good but the spring and clip need replaced.
asked by: Nathan E
0
Expert Reply:
For magnet clips we have a 4-pack, # BP19-001. Always good to have some spares. Magnet springs aren't available by themselves but you can get one in spring kit # AKBRKR-SP for 10 and 12 inch brake assemblies.
expert reply by:
Michael H
0
Product Page this Question was Asked From
Replacement Magnet Kit for 12" Electric Trailer Brake Assemblies - 5,200 lbs to 7,000 lbs
- Accessories and Parts
- Trailer Brakes
- Electric Drum Brakes
- 5200 - 7000 lbs
- Brake Magnets
- 12 Inch
- etrailer
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Search Results: 56070
- Shop: Mud Flaps
- Shop: Trailer Wiring
- Shop: Brake Controller
- Shop: Truck Mud Flaps - Black Rubber - 24" Wide x 30" Tall - Qty 2
- Search Results: prodigy p2
- Video: Uneven Rub Rail Trim for Enclosed Trailer Review
- Search Results: spring seats
- Shop: Spring Seat for Typical 8,000-lb, Round Trailer Axles with 3-1/2" Diameter
- Shop: Spring Seat for Typical 3,500-lb, Round Trailer Axles with 2-3/8" Diameter
- Shop: Grease Seals 10-36 (pair)
- Shop: Andersen Camper Wheel Chock and Leveler
- Shop: 4-Leaf Double-Eye Spring for 5,000-lb Trailer Axles - 25-1/4" Long
- Shop: Peterson LED Clearance or Side Marker Trailer Light w/ Reflector - 1 Diode - Rectangle - Amber Lens
- Search Results: 7 way
- Search Results: 10 36 seal
- Search Results: horse trailer step
- Search Results: water inlet
- Shop: Suspension Enhancement
- Q&A: What Causes a Brake Magnet To Fall Off After Removing the Hub
- Q&A: Replacement Axle Components For Dexter D80 8,000LB Axle Under 2016 Landmark Orlando 5TH Wheel
- Article: Testing Trailer Brake Magnets for Proper Function
- Article: Trailer Wiring Diagrams
- Q&A: What Ohms Should Trailer Brake Magnets Be?
- Article: Replacing the Bearing, Races and Seals on a Trailer Hub
- Q&A: Replacement Timken Bearings for Dexter Axle
- Q&A: Do You Have A Pre Greased 5200lb Hub Assembly That Is Galvanized?
- Q&A: How to Measure to Determine the Size Trailer Brakes Needed For Hydraulic Drum Replacement
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: How to Replace Brake Magnet on Dexter 12-1/4" 9K/19K Axle