Measurements of Holes in Mounting Base of Dutton-Lainson StrongArm Winch DL25001

Question

Question:

What are the anker bolt measurements for 25001? When you are using a direct pull?

asked by: DL

0

Expert Reply:

Dimensions for the hardware openings in the mounting place for Dutton-Lainson StrongArm Electric Winch # DL25001 are shown in the linked diagram. The instructions, also linked, indicate that the base and winch are to be fastened together using three 1/2-inch bolts, nuts, washers and lockwashers.

When attaching the plate to the mounting surface it is important that the entire mounting plate be supported by the surface under it.

expert reply by: Adam R

0

click to enlarge

Answer 1

The BoatBuckle Kwik-Lok Transom Tie Down Straps you mention, part #IMF17632 have a 1200 lb breaking strength, 400 working load limit (WLL) per strap. When determining the straps needed to secure a load of a certain weight, use the WLL figure. With…

view full answer...

Answer 2

The BoatBuckle Pro Series Tie-Down Straps, part #IMF17631, have a maximum tie-down length of 24 inches. The straps can be tightened down to a length less than 24 inches. You should have no problem using them if you have a tie-down length of 22…

view full answer...

Answer 3

We have the Dutton-Lainson StrongArm Electric Winch #DL24870 that comes with a 7/32" diameter x 25' long steel stranded cable. This has the same 3,000lb load capacity as the StrongArm #DL25215 that you were looking at with the strap. Maximum…

view full answer...

Answer 4

The Dutton-Lainson StrongArm Electric Winch #DL25215 doesn't come with a mounting plate but you can use part #DL24055 or #DL24059 if your current mounting bracket doesn't match with the mounting hole pattern for this winch (see attached).

view full answer...

Answer 5

Yes, you can! The Dutton-Lainson StrongArm Electric Winch w/ Remote item #DL25010 is a comparable replacement to your Sa9000 winch. They both have a 3,000 lbs capacity and a 7/32" diameter x 25' long cable. The corded remote control is…

view full answer...

Answer 6

There are two schools of thought when it comes to determining the correct sized winch for a boat. The first being that the winch should be able to handle 3/4th of the total combined weight of the boat along with the motor, fuel and gear. The second…

view full answer...

Answer 7

The Fulton XLT 2-Speed Trailer Winch part #F142425 as the title states has two speeds; a high speed which lets you retrieve your load much faster but it will be more strenuous and a low speed which makes it slower to retrieve your load but it will be…

view full answer...

Answer 8

When picking out a boat trailer winch the general rule of thumb is that you need a winch that has a capacity that matches at least 50 percent of the total trailer weight. So since your trailer weighs a total of 6,000 lbs a 3,000 lb winch like the…

view full answer...

Answer 9

The Dutton Lainson StrongArm Winch part #DL24874 (also known as the SA12000), can have a strap or cable attached to it. What you described is how you would replace the cable with a 2 inch strap for this winch.

view full answer...

Measurements of Holes in Mounting Base of Dutton-Lainson StrongArm Winch DL25001

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching