Would Thule Tracker Fit Kits Fit in Rhino Rack Track RTC15

Question

Question:

Your answer to the question about the Rhino Track RTC15 fitting the Yakima towers, can I assume that it is also compatible with the Thule TK1 pads also?

asked by: Richard K

0

Expert Reply:

Although it's never been tested yes, the Thule Tracker Fit Kits would fit in the track part # RTC16 as the Thule also uses track nuts that are 3/4 inches wide like the Yakima towers.

expert reply by: Jameson C

0

Answer 1

I took a look at your order and it was the Rhino-Rack Roof Rack for Factory Tracks - 54" Bars #Y02-480B-NT which is too short for the 63 inch spacing on your truck. For that spacing you will need the following: - Rhino-Rack Roof Rack for Factory…

view full answer...

Answer 2

Yes, the 63" Rhino-Rack RTC-Style Roof Rack Tracks - Channel Mount part #RTC16 can be cut down to the size you need as long as you cut them perfectly straight to allow the end caps to go back on because at this time we do not carry them as a…

view full answer...

Answer 3

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 4

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 5

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 6

Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…

view full answer...

Answer 7

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 8

Hi Paul, you’re definitely on the right track here, and I can help you narrow this down with confidence. With your tandem 3,500 lb Dexter axles and 33 inch spacing, both the Dexter EZ Flex part #K71-652-00 and the Lippert Road Armor part #LC53CK are…

view full answer...

Answer 9

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 10

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Answer 11

Hey Melanie. The reason you can't find a replacement for your GE ARC15AACBL2 15,000 btu air conditioner is because they phased them out. In 2025 all RV AC systems had to change over to a new coolant called R32. This was a EPA mandated decision.…

view full answer...

Answer 12

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Would Thule Tracker Fit Kits Fit in Rhino Rack Track RTC15

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching