Replacement Lens for Peterson M125A and M125R Trailer Marker Lights
Updated 10/26/2015 | Published 10/24/2015
Products Featured in This Question
Question:
Im looking for replacement parts for Peterson lights M125A and M125R, the below link shows the parts Im looking for. http://www.pmlights.com/products.cfm?cId=2andfId=1andpId=1402#M125R Are the 126A and 126R direct replacements? the dimensions look similar. thanks!
asked by: Karl
Expert Reply:
According to my contact at Peterson the correct replacement amber lens for your Peterson M125A light is part # 55-15A. This consists of a 2 x 2-3/4-inch lens and two screws. For a red lens use part # 55-15R. Both have a mounting hole spacing of 2-5/16-inches.
Please feel free to let me know if your lens' dimensions and mounting hole spacing differs from the above parts.
Product Page this Question was Asked From
Peterson Clearance or Side Marker Trailer Light - Incandescent - Chrome Plated - Red Lens
- Trailer Lights
- Clearance Lights
- Rear Clearance
- Rectangle
- Recessed Mount
- Non-Submersible Lights
- Incandescent Light
- 3-3/4L x 2-1/4W Inch
- Red
- Peterson
more information >
Continue Researching
- Q&A: Electric Trailer Jack Powered By The Towing Vehicle's 7-Way
- Q&A: Recommended Replacement Side Marker Light for Exiss Horse Trailer
- Q&A: Replacement Trailer Clearance LED Lights with 2 3/4 Mounting Hole Spacing
- Q&A: Replacement Slam Latch for a LCI Latch
- Q&A: Replacement Lens for Trailer Taillight SAE AP2 99 DOT
- Q&A: Replacement For Slide-Out Motor 130-1146
- Q&A: Replacement for P10490 Grease Seal
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: Curt Echo Full Review
- Article: Trailer Jacks
- Article: Best Landing Gear
- Article: Ram Trailer Tow Prep Package
- Article: Trailer Wiring Diagrams
- Article: Trailer Lighting Requirements