What Is The Recommendation For Welding Erickson E-Track System
Published 09/04/2015
Question:
We install E track in steel bodies. Can E track be welded in and if so what would you recommend for weld size and spacing?
asked by: RANDY R
Expert Reply:
The typical installation of the Erickson Horizontal E-Track, part # E19148 is by installing bolts or screws through the mounting holes on the track system.
It can be welded, but specific precautions should be used when doing so as this is a zinc-coated steel and welding produces dangerous fumes. It should always be done in a ventilated area.
In my research I found that the zinc coating has a lower melting point at 1,600 degrees F versus steel at 2,800 degrees F, and if not removed before welding can cause porosity and voids in the weld which can crack later. The best way to weld this is to remove the zinc coating before welding the tracks.
For stability many times we recommend installing hardware in every other mounting hole which would be every 4 inches. For welding, you would need to determine how many welds you need to use for the most secure installation.
Product Page this Question was Asked From
Erickson Horizontal E Track - Zinc Plated Steel - 2,000 lbs - 5' Long - Qty 1
- E Track
- E Track Rails
- Horizontal
- 5-1/8 Inch Wide
- 2000 lbs
- 5 Feet Long
- Erickson
more information >
Continue Researching
- Q&A: Welding E-Track in Place on a Steel trailer Recommendation
- Shop: Curt D-Ring Tie Down Anchor - Weld-On - 4-3/8" Wide - 6,000 lbs
- Q&A: Can E-Track be Driven Over and be Used to Secure Vehicle Tire To
- Shop: Trailer Hitch
- Search Results: a46pb
- Search Results: a86pb
- Shop: CargoSmart Forged Steel D-Ring Tie-Down Anchor - Weld On - 1/2" x 3-3/8" - 4,000 lbs
- Shop: Optronics LED Clearance or Side Marker Trailer Light w/ Reflector - 1 Diode - Round - Amber Lens
- Search Results: mcl0040abb
- Search Results: ps1401420303
- Search Results: a54gb
- Shop: LED Bullet Clearance or Side Marker Trailer Light with Grommet - 3 Diodes - Amber Lens
- Search Results: etracks
- Search Results: mcl55rb
- Shop: Optronics LED Trailer Clearance or Side Marker Light - Submersible - 3 Diodes - Round - Red Lens
- Shop: Single Wire Super Seal AMP Plug - 8" Long
- Shop: LumenX LED Trailer Tail Light w/ Grommet and Plug - 4 Function - 7 Diodes - Oval - Red/Clear Lens
- Shop: Trailer Wiring
- Video: Alpha Systems 4034 Roof Coating for RV Roofs Feature Review
- Video: Firestone Ride-Rite Air Bags with Easy Mount Compressor Feature Breakdown
- Q&A: What is the Difference Between a Class II and a Class III Hitch?
- Article: Trailer Wiring Diagrams
- Video: How to Choose a Trailer Brake Controller
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: What is the Difference Between a 4-Way and 7-Way Trailer Connector
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Q&A: Lug Nut Torque Chart for Trailer Wheels
- Shop: Suspension Enhancement
- Video: Curt T-Connector Vehicle Wiring Harness Review C56040
- Article: How to Choose the Right Trailer Hitch Class
on E Track
