Castle Nut Torque Spec for Trailer Axle
Published 07/01/2015
Question:
Hello, what torque should the center axle nut be? Is there a specific torque to it? Thanks
asked by: Ryan
0
Expert Reply:
When installing the castle nut on the end of the spindle, there is no specific torque rating.
The nut is ran down until there is no side to side play in the hub, and then backed off to the next notch in the castle nut so the retainer can secure the nut. Over-tightening the castle nut can damage the bearings, races and spindle.
If you click on the video link I provided, and fast forward to the 4:45 minute mark, you can see the procedure.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Dexter Trailer Axle Beam with Standard Spindles - 89" Long - 3,500 lbs
- Trailer Axles
- Leaf Spring Suspension
- Standard Grade
- No Hubs
- 3500 lbs
- Spindles Only
- 74 Inch Spring Center
- 89 Inch Hub Face
- No Drop or Lift
- Dexter
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Search Results: trailer leaf springs
- Shop: Camper Tie-Downs
- Shop: TorkLift Tie Downs - Custom Frame Mount - Front and Rear
- Search Results: ez lube grease cap trailer bearings races seals caps
- Search Results: bearing 14125a and 25580 trailer bearings races seals caps
- Search Results: trailer bearing kits
- Search Results: seal~cross~reference
- Search Results: 412920 seal
- Search Results: weight distribution hitch
- Video: Cleaning and Replacing Hubs and Bearings
- Shop: Brophy Slide In Camper Tie-Downs - Extra Clearance - No Drill Bed Mount - Qty 4
- Shop: Swing Out Extension Brackets for HappiJac Truck Camper Jack Systems - Qty 2
- Q&A: Correct Torque Rating for a Trailer Wheel Spindle Nut
- Shop: Brake Controller
- Shop: Trailer Hitch
- Shop: Timken Bearing Kit for Lippert, Dexter, and AL-KO Axles - 3,500 lb with #84 Spindle
- Q&A: Highest Rated Trailer Hitch for 2019 Ram 3500 with Factory Hitch
- Shop: Dexter Bearing Kit, 14125A/ 25580 Bearings, 10-36 Seal
- Shop: Vehicle Tow Bar Wiring
- Video: Review of the Replacement Hand Sprayer for Dometic RV Toilets
- Shop: TorkLift SuperHitch Magnum Trailer Hitch Receiver - Custom Fit - Class V - 2-1/2" and 2"
- Shop: TorkLift Tie Downs - Custom Frame Mount - Front and Rear
- Q&A: Can 4.80-12 Tire be Replaced with ST145/R12 Tire Using the Same Wheel
- Shop: RV Power Cord
- Shop: RV Electrical
- Shop: Base Plate for Tow Bar
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)
- Q&A: Can Bearing Buddy Bearing Protectors be Used on etrailer.com Hub Assembly # AKIHUB-440-2-1K
- Q&A: Castle Nut Torque Spec for 3,500 Pound Axle
- Q&A: What is the Torque Spec of the Spindle Nut on a Dexter E-Z Lube Axle