Replacement Electric Brake Assemblies for Denali Trailer with Tandem 5.2K Lippert Axles
Published 02/21/2015 >
Products Featured in This Question
Question:
I have a 2008 denali trailer. It has 2 lippert axles under it. The sticker says they are rated at 5200lbs each. I need to buy brake kits for it including magnets and hardware. What do you need from me to make sure I get the correct sets. I will need all 4. Thanks
asked by: Dave A
Expert Reply:
I'm assuming that you're simply replacing the existing brake assemblies and that your trailer has hub/drums that have an inside diameter of 12 inches and a depth of 2 inches. I'm also assuming that your existing brake drums are in good shape, and you're planning on reusing them.
If that's the case, I'd recommend the self adjusting electric brake assembly, part # AKEBRK-7R-SA for the right hand side, part # AKEBRK-7L-SA for the left. You'll need two of each. The brake assemblies don't include the hardware to mount them to the brake mounting flanges. You can reuse the existing hardware, but I'd recommend going with new. For each assembly, you'll need 5 bolts, part # 7-5, 5 nuts, part # 38N, 5 lock washers, part # 38LW, and two adjuster hole plugs, # BP10-220.
While you have the hub/drum pulled, be sure to examine the armature surface (inside of the drum that the brake magnet rides against). If the surface is grooved and pitted, you should probably replace the drums as well, because the grooves will prematurely wear the magnets on your new brake assemblies.
In order to recommend the correct replacement drums, I'll need to know the reference numbers from your inner and outer wheel bearings and the wheel bolt pattern. I'll link you to an FAQ article that explains how to determine the wheel bolt pattern.
Product Page this Question was Asked From
Electric Trailer Brake Assembly - 10" - Left Hand - 3,500 lbs
- Accessories and Parts
- Trailer Brakes
- Electric Drum Brakes
- LH
- 3500 lbs
- Brake Assembly
- Manual Adjust
- 10 x 2-1/4 Inch Drum
- etrailer
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: Replacement Dexter Brake Assemblies for 023-027-00 and 023-026-00
- Q&A: What is the Difference Between Trailer Wheels and Vehicle Wheels
- Q&A: Replacement Grease Seal for Axletek Hub BD-545
- Q&A: Which Brake Assembly Does Part Numbers B10E-21 & B10E-22 Correspond to?
- Article: Trailer Wiring Diagrams
- Q&A: Replacement Leaf Springs, Shackle Straps, and Equalizers for a 2006 Big Tex 70CH Trailer
- Q&A: Are Both Left and Right Hand Brake Assemblies in the etrailer Electric Trailer Brakes AKEBRK-6?
- Q&A: Replacement Trailer Brake Assemblies with Axletek-10-GG On Assemblies
- Article: Replacing the Bearing, Races and Seals on a Trailer Hub
- Article: How to Measure Your Trailer Wheel Bolt Pattern
- Article: Breakaway Kit Installation for Single and Dual Brake Axle Trailers
- Article: What Size of Boat Trailer do I Need?
- Article: Most Popular Wheel Bearings
- Article: How to Tell the Weight Rating of a Trailer Axle




