B and W Gooseneck Hitch Recommendation for a 1992 GMC Truck

Question

Question:

will this fit a 1992 GMC truck

asked by: Bert

1

Helpful Expert Reply:

Yes, the B and W Gooseneck # BWGNRK1050 that you referenced has been confirmed to fit your 1992 GMC Full Size Truck.

I attached installation instructions for you to check out as well.

expert reply by: Jameson C

1

click to enlarge

Answer 1

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Answer 2

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 3

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 4

For sag from towing a trailer the best recommendation I can make is actually a weight distribution system. Suspension enhancement will help level your truck while towing. But the advantage to a weight distribution system is that it levels the vehicle…

view full answer...

Answer 5

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 6

The airbags that I recommend for your 2018 Ford F-250 are the Air Lift LoadLifter 5000 Air Helper Springs part #AL57399. These airbags will not interfere with the B&W Turnoverball Underbed Gooseneck Trailer Hitch part #BWGNRK1116 as you can see…

view full answer...

Answer 7

Good morning, Ron! The Andersen Ultimate Connection 5th Wheel Trailer Hitch System #AN67VR is compatible with your factory gooseneck hitch ball just as it is. The Adapter #AN27VR you're looking at just gives you a better connection than the…

view full answer...

Answer 8

Yes, the puck system used on the 2016-2019 Chevy/GMC trucks is different than the pucks used on the 2020 and newer trucks. So you would need a 5th wheel like the B&W Companion #BWRVK3710 for your 2020 GMC Sierra 3500 with an 8' Bed. If you…

view full answer...

Answer 9

Hey Craig, it sounds like you are asking if the Andersen Ultimate Connection part #AN67VR can be used in the bed of your 2025 GMC Sierra short bed that has the OEM rail kit. If so, yes it can but you will need to use the pop in ball adapter part…

view full answer...

Answer 10

Choosing the right height setting for your 5th wheel hitch is a combination of a few different variables. First of all you want your towing setup to be as level as possible. With your Montana High Country 340BH level you will want to measure from the…

view full answer...

Answer 11

Hey Steve, The B&W Patriot #BWRVK3255 you have would require base rails or a gooseneck hitch and an adapter in order to mount to the bed of the F-250. If you want to go with base rails then I recommend the B&W Custom Installation Kit w/ Base…

view full answer...

Answer 12

Hello Dan, thanks for reaching out. The Firestone #F2550 for the 1999 Ford F-250 2WD will be compatible with the B&W Turnoverball gooseneck hitch. The brackets are designed specifically to be compatible with in-bed hitches like the B&W, so if…

view full answer...

B and W Gooseneck Hitch Recommendation for a 1992 GMC Truck

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching