Durable, UV-resistant cover lets you run your RV roof vent any time and in any weather. Angled louvers allow smoke, heat, and odors to escape while keeping rain and debris out. EZClip pins allow the cover to be opened or removed for easy maintenance.
Features:
Specs:
Note: Some vents may not open fully when used with this vent cover. If opened 50% or more, the vent will still achieve maximum airflow.
The MaxxAir II has a vent area that is twice the size of the vent area on standard covers. This provides more airflow in and out of your RV or trailer, and the side vents provide cross-ventilation for even more airflow. The angled louvers allow smoke, heat, and odors to escape while keeping rain and debris out.
This MaxxAir II vent cover comes with 4 EZClip pins. These pins enable you to easily open or remove the cover. When the pins are removed from one side, the opposite side acts as a hinge, allowing you unobstructed access to your roof vent for cleaning and maintenance. To secure the cover closed, slide the pins back into the cover and push them up to lock them in place.
The MaxxAir II vent cover is specifically designed for installation on 2015 and newer-model MaxxFan and MaxxFan Plus roof vents - no drilling or tools are required. The integrated mounting brackets on the MaxxAir II perfectly align with the mounting tabs that are molded onto the flange of the roof vent. To install, fit the cover over the roof vent. Then slide the included EZClip pins through the tabs and rotate them up to secure the cover in place.
If you're installing this cover over an older model MaxxFan or MaxxFan Plus roof vent without mounting tabs, no drilling is required, and all necessary hardware is included. The MaxxFan roof vent has pre-drilled holes in the side wall that are hidden under plastic plugs. Just remove the plugs and fasten the aluminum brackets to the side wall with stainless steel screws. Then insert the EZClip pins through the brackets to secure the cover in place.
If you're installing this MaxxAir II cover over any other roof vent, then drilling into the frame of the roof vent is required to mount the aluminum brackets. Stainless steel screws, nuts, and washers are included to install the cover. However, if you're installing the cover over a high-powered, high-speed ventilation fan, use the included self-tapping screws to mount the cover instead.
Do you have a question about this RV Vents and Fan?
Info for this part was:
At etrailer we provide the best information available about the products we sell. We take the quality of our information seriously so that you can get the right part the first time. Let us know if anything is missing or if you have any questions.
Thank you! Your comment has been submitted successfully. You should be able to view your question/comment here within a few days.
Error submitting comment. Please try again momentarily.