2014 Jeep Wrangler Lift Assist

Hi John; yes, the RM Reflex Steering Stabilizer #RM-RBK15-RSSC will fit your 1998 Chevrolet Express 3500 Class B RV.

Chevy stopped using a port to plug in a brake controller after the 2006 model year. The tow package wires to install a brake controller are still present up under the dash, to the left of the steering column, held together with a white tag. The wires…

Hello Phillip, thanks for reaching out. Yes, the Reese Dual Cam #RP26002 WD system can be used with a Reese Friction Sway Control #83660. As long as the head of your WD hitch has the pre-welded tab for the sway control ball (pictured below), the…

Hi Bill; I'm not surprised the #T53MR gives you a rough ride since it is the severe service kit. Timbren SES isn't overly forgiving to begin with, and this particular design is for constant loads like a slide-in camper. I would recommend the…

I have included a video that briefly goes over installing the Hopkins EasyLift Truck Bed Tailgate Lift Assist #74211 but we do not have a video that goes over the entire installation process. As you can see in the video you will need to drill a hole…

Hello Pj; we do not have an adapter for the Gorilla-Lift #GL1. However, as you can see in the picture below an adapter is not necessary for installation. This lift assist is perfectly compatible with round tube trailers as is. The only exception is…

Hey thanks for reaching out, Robert. Your Dexter P-15 model SLR 3,500 lb axle does use the standard bearing combination for a 3,500 lb axle. I was able to confirm this with Dexter. So, you have #L68149 for the inner bearing and #L44649 for the outer…

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

I looked at the install instructions for both the Hopkins EasyLift Truck Bed Tailgate Lift Assist part #74211 and the DeeZee Tailgate Assist Custom Tailgate-Lowering System part #DZ43300 for your 2003 Dodge Ram Pickup. They both install in different…

Hey John, thanks for reaching out! We have a variety of ways to get your cargo (and spare!) traveling down the road with you, and part of it just depends on what exactly you're looking to get out if it, along with how much you're…

Thank you for purchasing from etrailer! You did a great job selecting compatible parts. When using Leaf Springs #e64SR with the #AP233 Equalizer Kit and the #H248 Hanger Kit, there should be 29-1/2" between the front and center hangers and…

Spring Hanger location dimensions are normally figured by the manufacturer and provided with the spring hanger kit, that includes all of the parts for installing the springs on the trailer frame. I have provided a chart that shows the spring hanger…