Cold Air Intakes Specs:
Go confidently though deep water crossings by moving your air intake above your vehicle's hood. Snorkel improves overall engine performance by preventing water and dust from getting into your engine, giving you better air flow.
More Information >Videos
for Cold Air Intakes
Help Articles
for Cold Air Intakes
Expert Answers
for Cold Air Intakes
Hey Stephen, I would go with the SumoSprings kit part #CSS-1125R if you prefer a zero maintenance solution that once you install it you can basically never have to think about it again. The Air Lift air bag kit part #AL29PD would also work but it…
view full answer...The most beneficial component that you can add to your motorhome's suspension is a rear anti-sway bar or in your case, an upgraded rear anti-sway bar. For your 2014 Forest River Georgetown 360DS on a Ford F-53 Chassis, I recommend the Roadmaster…
view full answer...Your 2021 Tiffin Open Road 36UA is built on a 2020 Ford F-53 Chassis with a GVWR or 26,000lbs. This will accept the SumoSprings Rebel Custom Helper Springs #SSF-173-40-2 for the front axle and SumoSprings Maxim Custom Helper Springs #SSR-183-54-1 for…
view full answer...Let me see what I can figure out for you, I have the solution linked below: **SumoSprings Rebel Custom Helper Springs - 2 Piece - Front Axle #SSF-173-40-2. There was a generation change in the F-53 chassis, Ford changed the motor to the 7.3L V8. When…
view full answer...Since your Thor ACE is built on a 2015 Ford F-53 chassis then there are front helper spring options that will fit. I have included a link to them for you. For SumoSprings specifically if your model is rated for 24K to 26K GVWR then you can use…
view full answer...The bolt that is attached to the top of the SumoSprings Rebel Custom Helper Springs - 2 Piece #SSF-173-40-2 is a 3/8" x 3/4" flange bolt. This bolt is not offered as a separate part but you could easily go down to your local hardware store…
view full answer...The SumoSprings Rebel Custom Helper Springs - 2 Piece - Front Axle #SSF-170-40-2 are a confirmed fit and the two piece design does allow for the full suspension travel to allow your vehicle suspension to work to it's best capacity without…
view full answer...Everything I am seeing about a 2018 Tiffin Allegro 32SA is that it has a 24,000 lb chassis, so you'll want to verify what your chassis GVWR is before ordering. Here are the options for both the 22k and 24k front SumoSprings, with the right one…
view full answer...For your 2020 Forest River Georgetown 5 Series GT5 31L5 what you will need for the SumoSprings, front anti-sway bar, and steering stabilizer are the following: - SumoSprings Maxim Custom Helper Springs #SSR-180-54-1 - Roadmaster Rear Anti-Sway Bar…
view full answer...The most popular towing mirror setup we offer that fits your 2017 Hyundai Santa Fe Sport is the K-Source part #KS3891-2. This is a universal fit mirror setup that will fit and work well.
view full answer...First you would need a 4-way for your 2017 Hyundai Santa Fe to start for trailer wiring. For that you would need the part #C56332. Now if your trailer does not have brakes all you would need is the part #37185 as an adapter to convert the 4-way to a…
view full answer...Yes, you are seeing it correctly on some of the item #306-X7315 photos. That's 100% installation error. They're not cutting enough of the fascia off to let the safety chain plate clear it. The Curt Trailer Hitch item #C11422 does not have the…
view full answer...Filter Products (1)