Expert Review Video:
Vehicle Style: 2500 - 8 Foot Bed Change
Gooseneck Hitch Specs:
Recommended Trailer Wiring:
Installation Notes:
No drilling required to install the frame brackets of installation kit. Installation rails are rated to meet vehicle manufacturer's tow ratings - see vehicle owner's manual
More Information >Gooseneck Hitch Specs:
Recommended Trailer Wiring:
Installation Notes:
No drilling required to install the frame brackets of installation kit. Installation rails are rated to meet vehicle manufacturer's tow ratings - see vehicle owner's manual
Spare tire will need to be lowered or removed temporarily for hitch installation
Heat shield must be modified or trimmed for hitch installation
More Information >Gooseneck Hitch Specs:
Recommended Trailer Wiring:
Installation Notes:
No drilling required to install the frame brackets of installation kit. Installation rails are rated to meet vehicle manufacturer's tow ratings - see vehicle owner's manual
More Information >Videos
for Gooseneck Hitch
Help Articles
for Gooseneck Hitch
Expert Answers
for Gooseneck Hitch
The manual lockout on your Atwood 85778 surge brake coupler is there so that you can back up the trailer without the brakes locking up on you. Yes you can safely tow your trailer with the broken manual lockout, you just have to make sure you…
view full answer...The OEM prep package consists of 4…
view full answer...If you are needing the hub and drum assembly then you will want to go with the Dexter Trailer Hub and Drum Assembly #8-201-5UC3-EZ but if you are just looking for an idler hub then you will want part #8-213-5UC1 instead. These come with the correct…
view full answer...I really wish we had replacement parts still for the Atwood couplers but since…
view full answer...I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and…
view full answer...You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length…
view full answer...The number you provided,…
view full answer...The only way you could power interior dome lights on a trailer without it being connected to a tow vehicle would be to power the lights with a battery like a breakaway battery. How you choose to wire up the batteries will in the end be up to you,…
view full answer...For your enclosed trailer application I have several suggestions for adding interior lighting that you can control directly via a switch. Since your current 4-pole trailer wiring does NOT include a 12V auxiliary power feed that could power inside…
view full answer...Below is the general process for bleeding an electric over hydraulic brake actuator like #K71-650. Fill reservoir with NEW brake fluid. Never re-use brake fluid that has been salvaged or removed from another system. Remove the key from the…
view full answer...When installing/adjusting the Solera RV Slide-Out Awning #LCV000163285 tension is applied by rotating the awning roller 14 times. This should apply the needed spring tension so that the fabric…
view full answer...The length of wire desired depends on your vehicle connection and your personal preference. You want enough slack for turning, but not so much for dragging as you mentioned. A little extra slack…
view full answer...Filter Products (6)
Contact and Help
What our customers are saying:
I received this order yesterday. Thanks for the outstanding service. I appreciate it! Thanks, Alex
Alex
Blowing Rock, NC