2010 Toyota Tundra CrewMax - 5.7L V8 Engine Exhaust

Hi Bruce, To lift your trailer we'll first need to check of the suspension and see if you have torsion axles or a leaf spring suspension. If you have torsion axles then I'll need to see the axle tag in order to…

You have a good eye as the black tubing sections are plastic for the Camco Gen-Turi RV Generator Exhaust System #CAM44461. It's just the curved pipe section that is made out of stainless steel.

Hi Chris; your 2022 Ford Expedition will have a Normally Closed application, and it is possible when installing the Roadmaster Brake-Lite Relay Kit #RM-88400 that you'll need Hy-Power Diode #RM-790. I can't say for…

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

Both Firestone Ride-Rite kits are good options for your 2024 Ford F-250 Super Duty 4WD, but I like to recommend the 7,500 lb #F95FV rating over the 5,000 lb Rating #F35FV simply because it means the air bags can be used for the same application but…

I recommend going with the Air Lift LoadLifter 7500 XL Ultimate Air Helper Springs #AL89DQ for hauling around an in-bed camper with your 2024 Ford F-350 Super Duty. I really like this kit because it has the higher 7,500 lb rating (which you…

The air bag kit I recommend using for your 2022 Ram 3500 Cab and Chassis Dually is the Ride-Rite from Firestone: - Firestone Ride-Rite Air Helper Springs #F2478 I really like this kit because the air bags have the best construction on the market…

We have the following Gen-Y shock absorbing 5th wheel pin boxes which are compatible with the Lippert Rhino pin box bolt pattern. The weights listed below are the maximum capacities the pin box is capable of supporting. 21,000 lbs - 3.5K TW #GY86GR…

For a 2023 Jeep Wrangler 4XE you'll need the following components: Baseplate: Roadmaster Direct-Connect Base Plate Kit #RM-521453-5. These custom-fit baseplates are designed to work with factory bumpers, if you have an aftermarket…

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two…

That sounds right to me Travis, but while you have everything pulled out it wouldn't hurt to re-measure and double-check. The height shouldn't have changed and everything should essentially go as you've described,…

The tank that comes with the Air Lift WirelessAIR Suspension System for Air Helper Springs #AL27DQ is a 2-Gallon tank. When it comes to the physical dimensions, the tank measures 17" Long x 8" Tall x 6" Wide…