2005 Ford Mustang 4.6L V8 Engine Exhaust

When installing/adjusting the Solera RV Slide-Out Awning #LCV000163285 tension is applied by rotating the awning roller 14 times. This should apply the needed spring tension so that the fabric doesn't billow in the wind or leave enough slack…

According to my research, your 92865A-1 hub/drum has a 25580 inner and an 14125A outer bearing and a 8 on 6-1/2 inch lug pattern, as does the AxleTek #AKHD-865-7-2-K hub drum you referenced. The #AKHD-865-7-2-K would be an acceptable replacement…

We have toppers that'll work for 2 of your 3 sliders. For your 12 foot 9-1/2 slide, use #LCV000168109 which is designed for slides measuring between 152-157 inches wide. The longest topper we offer is for slides 188-193-3/4 inches, so…

I recommend to use the Solera 16-1/2' Slider part #LCV000435661 which matches the boxes width exactly so you will not have side overhang like we normally recommend but it is the biggest slide topper available to fit the 198" width of…

If you check out the picture I attached you can see that the roller and slide out awning assembly of the Solera RV Slide-Out Awning #LCV000435661 actually will sit below the awning rail so your setup having a tight clearance between the rail and…

Hi Bruce, To lift your trailer we'll first need to check of the suspension and see if you have torsion axles or a leaf spring suspension. If you have torsion axles then I'll need to see the axle tag in order to determine what you have so I…

You have a good eye as the black tubing sections are plastic for the Camco Gen-Turi RV Generator Exhaust System #CAM44461. It's just the curved pipe section that is made out of stainless steel.

You sure can! You'll just need to know the brand and model of your slide out awning. For example the Solera Slide out awning #LCV000168109 uses replacement fabric #LCV000442075. We only sell fabric for Solera awnings at this time (3/15/2023) so…

According to Solara (Lippert), the correct number of turns to set the proper tension of their slide toppers like #LCV000163285 is between 12 to 16 turns, so I'd consider 14 to be a pretty good happy medium.

The best way you can determine if your 2021 Ford F-150 has LED or Incandescent lights is to call the dealer with your VIN number and they should be able to tell you. If your vehicle has LED lights, you can use the Roadmaster Universal Wiring Kit with…

Ultimately you do not need a converter as you can wire the tail lights on your 2022 Ford F-150 to operate as brake and turn signals just like the lights on your motorhome. You will need to use the Roadmaster Universal Wiring Kit with Smart Diodes…

For vehicles where it's nearly impossible to find a dedicated stop light circuit the Roadmaster Universal Stop Light Switch Kit #RM-751000 is a great solution. Basically it gets power from your battery and has it's own switch that you install…