Filter by Trim Style

$25.30 - $25.43

$47.96 - $47.96

$50.81 - $259.99
Videos
for Trailer Trim
Help Articles
for Trailer Trim
Expert Answers
for Trailer Trim
Hey Jeff, the C part of the #PF98FR is 1-1/8 inch wide so it would fit over a 1 inch square tube.
view full answer...Hey Jeff, thanks for reaching out. I just went out to our warehouse and measured the P&F Products J-Channel Rail for Enclosed Trailers #PF26FR. The interior dimension of the J-channel I measured at 0.17". What thickness plexiglass were you…
view full answer...Yes, Rob - that’s one of the big advantages here with the PingMaster trailer tracker systems. The 3000 with WiFi backup #PM84FR, 5000 #PM64FR, and 5000 with WiFi backup #PM74FR are completely self-contained. They mount using the built-in magnet or…
view full answer...Yes, it is! The RV Flooring Adhesive for Vinyl Over Wood, Metal, or Concrete item #TS58FR is freeze-thaw stable to 15° F and would have to be heated up to at least 212° F once it has dried and cured. What kind of trailer do you have?
view full answer...Hello Mark; we do offer a variety of fender lights, so we very well may have a replacement for you. We do not have a direct replacement for the P2 05 S90 light that you mentioned though. After searching for a few pictures of these lights, what I saw…
view full answer...Hi William! Thanks for the picture of your axle tag. The correct bearing kit is the #BK3-200 with a 10-36 grease seal. If you want the Dexter version it is the #DX58ER, Are you getting your Momentum ready for spring/summer? Any big trips coming up?
view full answer...I recommend using the 601 Flooring Adhesive in a 1 Gallon #TS76FR or 4 Gallon #TS26FR depending on your application. The 601 does not have the pressure sensitive requirements of the 801, 1 Gallon #TS86FR and 4 Gallon #TS58FR adhesives.
view full answer...Hi Sofia! Yakima Tracks for Roof Racks can definitely be installed on the roof of your Tacoma. Well, as long as you have over 54" of roof to work with, so I do recommend measuring your roof to make sure you have enough room. The Yakima 54"…
view full answer...Hello Jake, Great question. I have a better option for you instead of wiring 2 of the Atlas IV Vaquero Self-Contained Hydraulic Trailer Jack - Bolt On - 10K #ST45FR, instead you can get the Atlas IV Vaquero Self-Contained Hydraulic Tandem Trailer…
view full answer...Hey David, thanks for reaching out! I highly recommend the Redarc Trailer Power Kit w/ Battery Charger and Monitor #RED37PR for your setup for a few reasons; it uses the 12V power from the 7-Way connector, Redarc battery chargers are proven and…
view full answer...We have a Lippert Components replacement slide motor that will work with the Schwintek system. It is the Lippert In-Wall RV Slide-Out Motor #LC236575. It is a gear ratio of 300:1.
view full answer...Hey Joe, great question. You’re thinking about it the right way. You can technically run the charge line from the 7-pin’s 12V power wire straight to the positive post on your battery, but with lithium you’ll want to do it safely. Your truck’s…
view full answer...Filters
- 6 results
Filter Results
Angle Trim
$25.30 - $25.43
Top/Bottom Rail Trim
$47.96 - $47.96
Tube Trim
$50.81 - $259.99