Install-ready options cover puck lights, strips, and dome fixtures that tie into 12V power. Match your old light by checking diameter, cutout depth, and mounting hole spacing, or choose surface mount when you don't want to cut. Some choices are dimmable and use simple black and white leads for hookup, making it easy to get bright, clean light where you need it.
Some 12V lights are dimmable, while others are not. Check that the light specifies dimmable operation and, if needed, whether it can connect to either a 12VDC or 24VDC power source or is for 12v only. Verify your switch or dimmer matches the light's requirements. If there's a built-in button, note size and feel to be sure it suits your setup.
Yes, 12V LED options can replace many fluorescent or OEM fixtures. Measure your existing light and hole spacing to avoid a unit that's smaller or with misaligned holes. Some swaps are an easy install and provide brighter light. Check if hardware is included—some lights do not come with screws—and confirm bulb or lens retention is secure.
Match the size and mounting of your current light. Measure overall diameter, cutout, and mounting hole spacing, then confirm it runs on 12V and ties into the existing black and white wires. If swapping trim rings, take care—some are hard to remove without breaking. If holes don't line up perfectly, be ready to adjust the mount.
Installation can be straightforward. If using a track, confirm the new strip fits the old track; you may need to solder a pigtail, cut to length, and weather-proof the cut end. For adhesive installs, clean the surface so the 3M tape bonds well, and note some rolls have leads on each end. Instructions can be small, so review them closely.
Filters
