Hi Mark, You shouldn't need to use the Furrion 7-Way Vehicle Power Adapter part #FR87PR because your 2018 Ram 2500 is from the fourth generation of the Ram 2500 before they did the huge overhaul that changed the circuits and resulted in the newer…
Hey Arkadius, welcome back! Yes, the ducted version of the Chill Cube comes with a remote. However, you're going to need the complete system for a replacement. You can choose from the following based on color: -Furrion Chill Cube RV Air…
Hey Craig! Is this a Lippert Ground Control system? Is the part actually 304136? I asked Lippert and they said they don't have anything under 304135. If it is the 304136 the correct replacement is the Replacement Control Module for Lippert Ground…
Hey Jerry, does the LED still light up on the front of the Mighty Cord SurgeMinder Surge Protector and Circuit Tester #SU39SR? If it was actually overloaded it would have damaged the internals of it and it wouldn't work as a surge protector any…
Hi Bill! You will need to completely replace the system since you have old Dometic R410a units on your Monaco. Everything switched to R32 refrigerant following new EPA regulations in 2025, and the new systems are not backwards compatible. For a…
Hey David, it sounds like you know what you're doing but I've also gone ahead and found the wiring diagram for the Replacement Single Zone Thermostat for Dometic RV Air Conditioners #DMC79FR for you to check out so you can use it as a cross…
Hey Kenny, welcome back! The reason for that note is because all of the new systems since 2025 use R32 refrigerant due to EPA regulations. Any 2024 and older systems use R410A and their parts are not compatible with the R32 units. It doesn't mean…
Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…
Hey Scott. The Furrion Variable Speed Chill Cube RV Air Conditioner w/ Heat Pump like item #FR97TQ in black or item #FR67TQ in white are only available in 18K btu capacities. The Chill Cube uses variable-speed technology, which allows it to reduce…
Hey Steve, yes the Dexter Nev-R-Adjust Brake Assembly set part #23-458-459 is the correct set for your Airstream based on the part numbers you mentioned. Also the hub/drum part #8-388-80UC3 that you referenced as well would be correct for your…
Hey Ken, welcome back! The Chill Cube #FR24TQ is just the rooftop unit. The #FR67TQ is the rooftop unit with the air distribution box (ADB) and the remote. This is everything you need for a complete installation. The #FR59TQ is the AC unit with the…
Hi Collin, welcome back! The most economical replacement is going to be from Advent Air. You will need a complete system since everything moved to R32 refrigerant. If your upgraded thermostat is R32 compatible, or a smart thermostat that got a…
Brighten up your camper with Custer RV interior lights in white for a clean, crisp look. Swapping a whole fixture is a straightforward way to avoid dealing with proprietary LED boards or soldered parts, and wiring hooks right in so you can get back on the road. A practical upgrade that fits well and works great indoors on trailers and RVs.
Yes, you can hook it up to a 12V battery to test function before installation. This helps confirm brightness and wiring polarity. Use brief contact to avoid sparks and verify the light powers on as expected. Once confirmed, proceed with the permanent connection in your RV or trailer.
Installation is generally straightforward with a simple two-wire hook-up. Match positive and negative, then mount the fixture. Bench test first on a 12V battery to confirm operation and wiring. If replacing an older light, verify your existing power and ground leads are accessible and long enough to reach the Custer leads.
Yes, if your current fixture uses a proprietary LED board, swapping the entire light is the straightforward fix. These are generally not designed for easy bulb replacement and boards may be soldered in. A Custer 12V LED dome-style light uses a simple two-wire connection. Before removing the old unit, confirm your system is 12V and note power and ground leads.
Yes, it's designed for 12V RV and trailer interiors and can wire right in. Verify you have a 12V supply where you're mounting it. Check that your mounting surface suits the fixture's footprint, and confirm the wiring leads can reach. After install, ensure the light operates and stays secure during travel.
Filters
