Hey Bob, thanks for reaching out, and good question. For that setup, as long as the tray is properly secured in the portion that is touching the floor, it will be just fine. It might be a bit more difficult to install since you can't secure the…
Hi Chuck! The MORryde RV Cargo Slide Tray - 72" x 26" - 1 Way Slide - 60 Percent Extension - 800 lbs #MR67FR sits 1.6 inches above the floor you mount it on. If you want or need it to be a bit higher off the floor, you can also grab the…
Hey Ethan. From the mounting point of your RV to the top of the carpeted base is going to be 2.31" on the MORryde RV Cargo Slide Tray item #MR78RV. The bottom of the tray sits 1.57" above the mounting point on your RV and the wooden base is…
You can go with a listed 29" model of the MORryde RV Cargo Sliding Tray as its actual width is 28-3/4". Please note the attached image showing dimensions of width. We have the #MR69FR that is 90" in length by 29" wide and has a 2…
Hi Glen, It will depend on what the GVWR (gross vehicle weight rating) is of your trailer to determine which B&W 5th wheel to gooseneck adapter will work best for you. Fifth wheels and gooseneck trailers go off of pin weight instead of tongue…
While there is no visual guide available to determine the sizing for the MORryde sliding cargo trays like the #MR38FR, it really depends on the height, length, and depth of your RV compartments opening. The #MR38FR that you were looking at, for…
Hey Arthur, The dimensions I'm seeing for a 3500watt Predator Generator show it being 22.8" L x 17.3" W x 20" T so if you're wanting it to sit with the 17.3" side facing out the closest fit would be the MORryde RV Cargo…
Hey Paul! The PullRite SuperGlide #PUL43RR (2714) and #PUL73RR (2914) do weigh the same. The main difference is the capacity, which is going to come from the base of the 5th wheel hitch. Since your 2027 Keystone Cougar 316RLS has a GVWR of 12,900 lbs…
Hey Mike, welcome back! Both the Firestone Ride-Rite #F2613 rated for 5,000 lbs, and the Firestone Ride-Rite Red Label #F2709 rated for 7,500 lbs will keep you at factory ride height when you aren't towing. All you need to do is run the air bags…
The two most likely causes of a MaxxAir vent fan lid not opening or closing are either going to be a lift motor or operator failure. I recommend removing the motor and applying power directly to this to see if the shaft turns. If not, you know the…
Hello again Bob, On the MORryde RV Cargo Slide Tray - 90" x 29" - 2 Way Slide - 60 Percent Extension - 800 lbs #MR69FR the overall dimensions are 90" long x 29" wide x 6-5/8" tall, the actual tray dimensions are 88-1/4"…
Easy place to shop. Fast delivery and great products. Very happy with my purchase.
Ed
Boynton Beach, FL
RV Cargo Slides with 80 Percent Extension, 23 Inch Wide
Built for easy access, these RV cargo slides give you reach with 80 percent extension while keeping things steady. The 23 inch wide design suits tighter compartments and helps you make the most of your storage space.
Yes. Confirm the tray's listed size uses outside dimensions, then compare to your available space. Mock up the footprint and slide path to ensure smooth travel. Verify total weight and mounting options so your platform and fasteners suit the install.
Some include extra bolts depending on how you want to attach it. Check the hardware list to see what fasteners are included and match them to your mounting surface. If you need specialty anchors or lengths, plan to have those on hand before installation.
Start with the outside dimensions. Some list the size as the outside dimensions, which makes it easier to order for your space. Measure the opening, depth, and any door or latch clearances. Verify the mounting footprint and that the slide path clears seals and frames.
An 80 percent extension slide brings the tray most of the way out. Arrange gear so frequently used items are within easy reach when extended. Check your bay depth and door swing to be sure you can reach what you need, or place heavier items toward the front of the tray.
Filters
