1986 Maserati BiTurbo Catalytic Converters

For your 1996 Chrysler Intrepid we have the Drivers Side Front #MF50205 and Passenger Side Front #MF50204 direct fit catalytic converters. These will fit both the 3.3L and 3.5L engines. We do also have the Rear Converter #MF23286 for the 3.3L and the…

The Dexter 8-427 hub is no longer available. Even looking through Dexter's site the only references to it are replacement bearings. You can use a wheel with a larger pilot hole as long as the wheel attaches to the hub using lug nuts and not…

Generally speaking no, the direction of exhaust gases does not matter when passing through a catalytic converter like the MagnaFlow Stainless Steel Catalytic Converter part #MF23882. If the direction of flow does matter then it will be stamped onto…

Hey Nate. All the connectors are going to seal up about the same and have identical issues. What you need to do is use Dielectric Grease item #11755. It covers your contact points and keeps moisture away. It also helps with conduction. To add a hitch…

Hello Blake, thanks for reaching out. I did some digging and I was able to find a reference for the 92655 hub. This uses the 15123 inner bearing and 25580 outer bearing. It will be a 12" drum as well. This reference didn't tell me the bolt…

California's emission control standards are stricter than most states. This is why many auto parts, like the MagnaFlow #MF93257, are not approved in California but are in other states. It's referred to as CARB certification because of the…

Hey Steve, great question but just changing the wheels and tire will will not affect the fit of the air bag kit and compressor you plan to install on your 2024 Ram 2500. The only thing that does change things is if you were to install a lift kit…

Based on the photo and information you provided, I can tell you have 12 x 2 inch Dexter brake assemblies for 5.2K axles, for which the Electric Trailer Brake Kit #AKEBRK-7-SA will be an excellent replacement. These are self-adjusting brakes so they…

To manually retract your slide-out you'll need to use a 5/8" socket on your Gear Motor Assembly for Lippert Electric Slide-Out #LC386327.

We have 2 different remotes available for HappiJac electric camper jack systems. - Replacement Remote Control for HappiJac Electric Camper Jack Systems #LC723915 - Replacement Remote Controller for Wireless HappiJac Electric Truck Camper Jacks…

Your Dexter D120 axle is rated for 11,999.80lbs, has a spring center measurement of 45.5" and track width of 74". It is an underslung axle that uses 3" wide 30" slipper springs rated at 6,000lbs each. The brakes are 12-1/4" x…

Hey Joe, thanks for reaching out. Your coffin trailer idea sounds killer! I was able to find a few pictures of similar trailers on google and a lot of those things look pretty cool so hopefully I can be of some help here. I can definitely see the…