2023 Ford F-150 Lightning Vehicle Cargo Control

Hello David, The reason it’s $1000 more is because of the whopping 0.2 cu. ft. of extra space..... just kidding! The main difference comes down to the exterior and features. The #GE48FR has a sleek glass front that gives it a glossy, modern look,…

Hello Ron. Sadly, the Front Runner Propane Tank Holder #FR47FV will not fit a 20 lb propane tank. According to Front Runner, out of the box it will work with an 11 lb tank. If you need a tank to use with it, take a look at the Ignik Gas Growler X…

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

Hi James; according to Yakima the correct MOD HomeBase for your 2024 GMC Yukon XL is the Medium #Y83DJ. The #Y55DJ is too large to fit. You will have anchor points similar to the picture below in the rear to secure the straps.

Hi Kev; the MORryde RV Cargo Sliding Tray with the 80% extension is only available at 72" long x 48 " wide #MR52FR. If you're alright with a 60% extension we have the MORryde RV Cargo Sliding Tray - 60" x 48" #MR85FR.

Hello Nick, The Hitch ball for the Curt #C60642 will sit above or slightly forward of the rear truck axle. I attached 2 pictures of the underbody of the 2022 GMC Sierra, as you can see that the Curt #C60642 sits in the same spot as the B&W…

Hey Jack, If you're talking about a transition plate then you'll want the etrailer Enclosed Trailer Transition Plate #e32JR. This can be installed on either end of the ramp to help make the transition onto easier or at the hinge of the ramp…

Hey Chris, Our Fitguide can be a bit confusing sometimes. Essentially the whole category is broken down into whether they fit diesel or non-diesel models. Since the EcoHitch Hidden Front Mount Trailer Hitch Receiver #EH37FR fits both gas and diesel…

Yes, it does Matthew! The Weigh Safe 180 Hitch 2-Ball Mount for 2.5" Hitch item #WS74MR is designed for and will only fit a 2-1/2" receiver.

Tony, it sounds like you're looking for something like the etrailer Soft Tonneau Cover #e52DR for a low profile or #TX279101 for a standard profile. These tonneau covers sit on top of the bed rails, are a soft roll-up style, and sit 1 1/4" (…

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

Hello Codi, I reached out to our friends at GE about the Amp draw for the GE Profile RV Refrigerator w/ Freezer #GE48FR and this was their response: This is a great question we hear often, its not as easy to answer. The refrigerator spec calls for…