Most Popular Hitch Extender for 2000 Jeep Cherokee

I needed my bike to clear my bumper on a front hitch and this did the trick. This extender is hollow so I was able to use anti rattle/ lock before adding bike rack.

Click to Enlarge

Click to Enlarge

Allows me to use my back rack and small boat trailer without having to remove the spare tire on my Jeep Wrangler. Works well.

I got this hitch extender to put on my camper so that I could mount my bike rack. It worked like a charm!! The bike rack and bike were super solid on the trip cross country!!

Click to Enlarge

Perfect for my application.

Works great! I use it on my motorhome to carry my bikes with a Rocky Mounts Carrier and flat tow my car with my Blue Ox system. It places the bike carrier at an optimal height over the front of the car but my may be different for other bike carriers. Very sturdy and seems to be quality all around.

Definitely a quality product. Just installed and it's very solid. Fits perfectly on the Torque Lift Hitch

Click to Enlarge

Torklift SuperTruss does not disappoint. Straight forward install, though the manual photos are extremely dark. Use the Torklift YouTube install video if needed. The 48” extension gives me the needed length beyond the TC I was looking for while still allowing 1,200 tongue and 12k overall towing capacity.

Click to Enlarge

It works great,by moving the trailer back from the vehicle you can load longer items,so there are not hanging over the back of the trailer. It also helps in the backing of the trailer. Thank You

Click to Enlarge

I would like to have the actual distance from the weld joint to the hitch pin hole of 4 1/2". This unit is slightly less than that.

Great product. Needed this for two reasons. 1. I needed to be able to load both bikes and a cargo carrier on the back of a Jeep Cherokee. 2. I also needed more room between the bike rack and the rear cargo door to load and unload with out having to tilt the bike rack.

Used the Malone 2" Dual Purpose Hitch Receiver to have a bike rack with two bikes on the upper Receiver and a 21' bassboat on the lower Receiver. Ran down to Florida Everglades, Florida Keys and back home. Almost exactly 4,000 miles. Hitch worked perfectly. I did find that you can not "jacknife" the boat as much or the bow of the boat will touch the bikes on the rack but that is to be expected. Hitch was quiet, strong and exceeded my expectations. Easy to install and looking forward to using it again in a month for another 4,000 mile road trip. Note: I drive fast and the roads are not always perfect. This is a sturdy Hitch Receiver. Hope this review helps you. Sorry, crummy photo as the Receiver is a "set it and forget it" product. Be well.

Click to Enlarge

Works as advertised. I use it full time. I painted the step surface with Herculon bed liner for a rubberized non slip surface, that works even when covered with frost or mud. Only down side, is that it reduces the tongue weight of the truck hitch by 50%. I typically use it to haul a 2 horse trailer. If it ever gets damaged, I will immediately by a replacement.

Click to Enlarge

Affordable front step (wide platform) to service lifted vechicles and will provide distance between exterior mounted spare tire and hitch rack. Suggestion: design the step to fold up or down for a full time install.

Works well on my side by side to get the ball to a usable reach. The threaded pin makes it difficult to take on and off (can't use a non threaded in). I have to lay on the ground to do this. It does not rattle that is for sure so in an application where that is important, and where you have normal access I am sure it is fine. I simply needed this specific length.

My wife and I purchased a travel trailer a year ago. The tailgate of my truck was too close to the trailer to allow it to open. I purchased the extension from you to eliminate that problem. I purchased this one because it is 2" solid and had a 10k rating.

Product is exactly as described. Shipping was perfect, received sooner than expected. Would buy from etrailer again for sure.

I was surprised by just how solid and heavy it was made. Just what I needed to move my Bobcat UTV hitch back to I can use it as my yard dog to shift my trailers around and not worry about the plastic tailgate nor the plastic bed getting damaged. The hitch sits under the bed and this extends it out so it is useable.

Click to Enlarge

Who do I contact about getting the right extension bar? The one I ordered Is a 2 1/2 inch which I need a 2 inch to slide into my receiver or if you guys have a 10 to 12 inch, 2 inch extension so I can connect it I sent a photo of the end that is 2 1/2 which I need it to be 2 inches to slide into my receiver

Click to Enlarge

Received the product on time and as described however two days later I found it on Amazon for $167 vs the $XXX I paid from etrailer. When I called to see about a price adjustment - they couldn’t assist and offered return and re-purchase from Amazon - minus a $XX return shipping. Lesson learned.

This tow bar extension is a quality built product.. Very helpful backing a trailer.

Product is just what we needed and we put it to use immediately with no problems. It enables us to freely engage the rear lift door of our vehicle with my handicap scooter loaded on it's carrier. Great for us.

The items I ordered will allow me to adapt my utility trailer for transporting my sea kayaks. Curt and Hopkins are both quality manufacturers. On a shipping note, the box arrived at the Post Office broken wide open. Your shipping folks need to wrap small, heavy, items in bubble wrap. Then stabilize it with foam peanuts. Just putting it in a box then stuffing the box with craft paper does not cut it. Items were not damaged so I am good to go.

I think it is a great product but expensive. In retrospect I could not do what I wanted with the truck and hitch so I spent the money needlessly. Not any fault of your company. I would have been just as well to leave the stock OEM and not spent the money anyway. Live and learn.

At first I was skeptical but now that I’ve put it together I’m very impressed. This thing is heavy duty and pulls my trailer no problem. Korren did a great job helping me out. Excellent customer service.

Click to Enlarge

Just received the 41/48 inch hitch extension today so haven’t actually used it. However, one can tell the high quality by looking at the welds and thick paint coating. This item is extremely heavy. I expected some weight to it, but it surprised me. Also, the tubing has very tight tolerances. I have two ball mounts, neither of which slid into the extension on their own. I had to pound them in and tap them out with a 3 pound hammer. Once paint and labels were scraped away by this action the ball mounts were able to be slid in by hand. This extension will be used on my dually carrying my truck camper. I’ll be towing an aluminum trailer with a Can Am Spyder. Total weight towed will be less than 2000 pounds so I don’t expect the extension to be subjected to any stress.

As per my last 3 orders here are some pictures of how I received the item along with what was broke or bent. I can fix it but I shouldn’t have to. So I will try elsewhere from now on cant deal with your shipping dept , anymore.

Click to Enlarge

Click to Enlarge

I had to remove burrs from the inside of the tube, both at the holes drilled (for hitch pin) and the end where the ball hitch goes in. The welded boss on the end of the tube had burs left over from the cutoff operation. The ball hitch would only slide in a couple of inches prior to deburring it. Also the packaging was not very good, see pictures. No damage to the product but I am surprised it even stayed in the box during the trip here, it was completely loose in the box and tore it apart during transport.

Click to Enlarge

Click to Enlarge

The product is good the packaging for shipping needs improvement. The box came ripped in half and only the tape on the bottom of the box was holding the box together. The plastic cap for the one end was broken and unusable. The other end had a dent in the metal that had to be filled down to be able to insert it into the receiver. The bracket for the plug extension to mount into the hitch extension was bent together so it had to be bent back straight. This was to be able to insert the plug and line up the 4 holes to be able to mount the receiver plug to the extension.

The hitch worked great. I pulled a 12ft Wells Cargo enclosed trailer with a motorcycle on board. The reason I purchased this hitch, I have a 101/2 ft Lance camper that extends pass the bumper. I used it on a F350. I did use a Equla-I-Zer sway control hitch because of the tongue weight of my trailer and I believe it made this extension hitch work better.

This is a quality product and works perfectly! Easy to install and adjust. They even give you extra chain and turnbuckles.

We have been using Torklift superhitch and supertruss extension since 2010 hauling horses around the US. This extension and superhitch went on our new truck. We hauled trouble and worry free for 10,000 miles this year. Best product on the market.

Click to Enlarge

This is the second super hitch truss system I have purchased. Never disappointed