# 1
Hitch Extender For 2" Trailer Hitch Receiver 7"
Allows me to use my back rack and small boat trailer without having to remove the spare tire on my Jeep Wrangler. Works well.
The Brophy hitch extender was well built and delivered the tongue weight I needed to carry my e-bikes. It did accept the Hollywood RV Rider bike rack. It did not however fit appropriately with my Drawtite hitch to allow the use of an anti-rattle bracket. This allowed too much movement of the bike rack.
# 2
Roadmaster Dual Hitch Receiver Adapter, 2" or 4" Drop/Rise
Meaty and does the job. With an additional 1-1/2" drop built into my Demco Commander II tow bar, it's a perfect fit to hitch my 2021 Jeep Wrangler to my 2020 Winnebago View. I haven't tried it yet, but I'm hoping to be able to fit a bike rack between the two vehicles.
I purchased this product to add a platform above my tow bar. I flat tow a Jeep Wrangler unlimited behind a Monaco Windsor Motorhome and have no place to carry a spare tire. I will build a tire rack to fit the top receiver. I trust Roadmaster Products. and etrailer.com's price and service is outstanding. Great job etrailer.com
# 3
MaxxTow Trailer Hitch Receiver Adapter - 2" to 1-1/4" Hitch - 11" Long
Functions as designed: The extension allows my bike rack to clear the rear tire on my Jeep. I added a tightening lock to secure it in place and now have no rattle or shake on the rack. Happy Jeep Owner
This item worked great for my bicycle rack that I installed on my jeep. I have a 2" hitch on my bumper. Needed a 1-1/4" adapter hitch, so my bike rack would fit.
# 4
Advantage SportsRack Hitch Extender for 2" Trailer Hitches - 11" Long
This extension works as advertised and allows plenty of clearance from the rear mounted spare tire on my Jeep Wrangler. Please note this product is for use when attaching a bike rack and not for towing trailers and such.
# 5
Roadmaster Dual Hitch Receiver Adapter for Tow Bars - 2" Hitches - 2-1/4" Rise/Drop
Beefy. I have no doubts of the capacity of either side of this hitch adapter, there's plenty of weld to hold it all together. Very few options will provide minimal drop (for an off-road trailer) and minimal rise on the other side for an additional bike rack or cargo carrier. Jeeps are tough since you need to be able to open the gate. This one clears no problem. My spare is up on a slant back carrier, but I think the stock spare should clear as well. Get you a "Trimax THC200 Universal Anti-Rattle Clamp Fits 2" Hitch" and this thing is solid as stone.
The hitch has held up over Alaskan roads towing a jeep, but it does not sit level in the receiver so the tiny little bit that it sags is exaggerated when the tow bar is connected. Paint starting to peel with wear after a year.
# 6
Titan Hitch Box Extension for 2-1/2" Trailer Hitches, 41" - 48" Long
Just received the 41/48 inch hitch extension today so haven’t actually used it. However, one can tell the high quality by looking at the welds and thick paint coating. This item is extremely heavy. I expected some weight to it, but it surprised me. Also, the tubing has very tight tolerances. I have two ball mounts, neither of which slid into the extension on their own. I had to pound them in and tap them out with a 3 pound hammer. Once paint and labels were scraped away by this action the ball mounts were able to be slid in by hand. This extension will be used on my dually carrying my truck camper. I’ll be towing an aluminum trailer with a Can Am Spyder. Total weight towed will be less than 2000 pounds so I don’t expect the extension to be subjected to any stress.
As per my last 3 orders here are some pictures of how I received the item along with what was broke or bent. I can fix it but I shouldn’t have to. So I will try elsewhere from now on cant deal with your shipping dept , anymore.
# 7
Draw-Tite Hitch Extender for 2" Hitch Receivers - 18" Long
Perfect for my application. My rack now clears the spare time on my Jeep Wrangler.
I was surprised by just how solid and heavy it was made. Just what I needed to move my Bobcat UTV hitch back to I can use it as my yard dog to shift my trailers around and not worry about the plastic tailgate nor the plastic bed getting damaged. The hitch sits under the bed and this extends it out so it is useable.
# 8
MaxxTow Hitch Extender with Step - 2" Hitches - 13-1/2" Long - 7" x 14" Platform
Works as advertised. I use it full time. I painted the step surface with Herculon bed liner for a rubberized non slip surface, that works even when covered with frost or mud. Only down side, is that it reduces the tongue weight of the truck hitch by 50%. I typically use it to haul a 2 horse trailer. If it ever gets damaged, I will immediately by a replacement.
Affordable front step (wide platform) to service lifted vechicles and will provide distance between exterior mounted spare tire and hitch rack. Suggestion: design the step to fold up or down for a full time install.
# 9
Hitch Extender For 2" Trailer Hitch Receiver 14" Long
Very nice, heavy duty extension.
It works great,by moving the trailer back from the vehicle you can load longer items,so there are not hanging over the back of the trailer. It also helps in the backing of the trailer. Thank You
# 10
Curt Hitch Extension and Reducer for 2-1/2" Trailer Hitches - 24" to 34" Long
Who do I contact about getting the right extension bar? The one I ordered Is a 2 1/2 inch which I need a 2 inch to slide into my receiver or if you guys have a 10 to 12 inch, 2 inch extension so I can connect it I sent a photo of the end that is 2 1/2 which I need it to be 2 inches to slide into my receiver
Received the product on time and as described however two days later I found it on Amazon for $167 vs the $XXX I paid from etrailer. When I called to see about a price adjustment - they couldn’t assist and offered return and re-purchase from Amazon - minus a $XX return shipping. Lesson learned.
# 11
Hitch Adapter 2" to 1-1/4" Trailer Hitch Receiver - 7" Long
The hitch arrived as promised and is as described. It's just what we were looking for to adapt our bike carrier for use on our new Jeep Wrangler.
Great product. Meet my needs. I used it on my Wife's Jeep Wrangler to extend her bike rack away from the spare tire
# 12
Hitch Reducer 2" to 1-1/4" Trailer Hitch Receiver
This has worked great to reduce my 2" hitch so that I can continue to use my 1 1/4" Thule bike rack, and I like that it doesn't extend out much from the hitch. After my last trip though, the inset separated from the larger piece. I can still use it, but without the smaller piece fixed in place, I can't put it on the car first and then slide the bike rack into it since the smaller piece slides, and it's impossible to line the holes up. It's also rusted more than I expected. It wasn't inexpensive, and I was hoping it would last longer. I've used it for maybe a dozen trips.
Perfect fit BUT the inner tube broke away from the outer tube after about a dozen trips. One small weld on the outside corner is all that holds it on. The small amount of play must have been too much for it. I was even using an anti-rattle lock pin. Very disappointing due to the price point. And now it’s unsafe to use as it could slip right out of the receiver.
# 13
Curt Extender for 2" Hitch Receivers -18" Long
Received my 18" extender for my 2" receiver in 3 days. It's going to work perfectly, enabling me to haul bikes with the Thule spare me bike rack at the same time as cargo on a luggage rack at the end of the 18" extender on my Jeep Wrangler. Product is super heavy, therefore, super durable.
I got this hitch extender to put on my camper so that I could mount my bike rack. It worked like a charm!! The bike rack and bike were super solid on the trip cross country!!
# 14
Roadmaster Dual Hitch Receiver Adapter, 2 " or 8" Drop/Rise
I need an 8 inch drop between my Itasca motorhome and the Jeep Wrangler I tow behind it. Had a basic Roadmaster drop hitch before I added a bike carrier. Daisy-chained a dual hitch adapter in and was ok going to Florida from New England and back last winter with the two adapters in line together. But heading to Alaska this summer and wasn't comfortable with the extra points of failure. This Roadmaster hitch gives me the drop I need for towing and the second reciever for the bike rack in a single safe package. And kudos to eTraileelr for the very fast shipping. We leave for the great north tomorrow!! .
The Hitch adapter works great. It lined up perfectly with my Jeep Wrangler w/ 4 inch lift. I’ve used it on my Winnebago mainly for long trips and it is a beast! Tows the Jeep easily.
# 15
Reese Titan Reducer Sleeve 2-1/2" to 2"
This ain't pretty. But size does matter. The 58102 2" X 2 1/2" receiver adapter hits the spot. It fits nicely into the 2 1/2" receiver with, at most, 1/8" space "slap" room. It's almost full length front to back inside receiver providing plenty of support for my 2" weight distribution system without slap. I have not hooked up my Forest River 29'4", 10,7 75 lb. GVWR Puma tow behind R/V but I do not have any fear of this well constructed, perfect fitting receiver adapter. The people at etrailer are there, willing and able to assist you. I have personally found that, if the C.S. Rep doesn't know the answer, she/he will find the answer and report back to you, in my case within minutes. My purchase was delivered (snail mail) within 5 days and In excellent condition. I will report back shortly after a trial run hooked up.
This fits a Curt 2 1/2 receiver perfectly. Allows me to use receiver with my various drawbars for different trailers when I am not using the Forklift hitch box extension.
# 16
Roadmaster Dual Hitch Receiver Adapter, 2" or 10" Drop/Rise
Excellent service, good prices and super fast shipping. 2 different orders arrived in 2 days! Thanks for everything eTrailer and William!
Well built product and did what I needed it to do. The rise part of the receiver to install a bicycle rack to keep it above my tow vehicle a lifted Jeep Wrangler. The only negative is the receiver tube on the bottom now drops the hitch basically 2 1/2 inches lower and I now drag the receiver on the ground on driveway / street dips. Would have been better if none rise came straight out. I don’t think I would drag then I should have done more measurements
# 17
I ordered this adaptor because the 1 5/8" receiver welded to my '99 Jeep Wrangler was useless. Nothing is 1 5/8". Because the Jeep has been on more than it's fair share of truly crappy goat paths, the receiver had been tweaked a bit out of shape, and the adaptor didn't fit. However, a few minutes with a grinding wheel applied to the adaptor remedied the situation. The Brophy adaptor now fits just fine, I can now use 2" hitches, and I am a happy camper.
Thank you for the 1 5/8ths - 2 inch adapter. This product is not easy to find. Shipping was fast, and fits great. Fantastic follow-up all the way from shipping to receiving. Will be shopping with you again.
# 18
Hitch Box Extension and Reducer for Titan 2-1/2" Trailer Hitches, 24" - 34" Long
I had to remove burrs from the inside of the tube, both at the holes drilled (for hitch pin) and the end where the ball hitch goes in. The welded boss on the end of the tube had burs left over from the cutoff operation. The ball hitch would only slide in a couple of inches prior to deburring it. Also the packaging was not very good, see pictures. No damage to the product but I am surprised it even stayed in the box during the trip here, it was completely loose in the box and tore it apart during transport.
The product is good the packaging for shipping needs improvement. The box came ripped in half and only the tape on the bottom of the box was holding the box together. The plastic cap for the one end was broken and unusable. The other end had a dent in the metal that had to be filled down to be able to insert it into the receiver. The bracket for the plug extension to mount into the hitch extension was bent together so it had to be bent back straight. This was to be able to insert the plug and line up the 4 holes to be able to mount the receiver plug to the extension.
# 19
Hitch Adapter 1-1/4" to 2" Trailer Hitch Receiver
Very heavy duty. Will use it with a bike rack I had for another vehicle that had a 2" receiver.
Solidly made. Wish all of these would come with optional locking pins and clamps to minimize movement as I use mine primarily for a bike rack with very nice bikes aboard.
# 20
Curt Hitch Extender for 2" Trailer Hitches - 14" Long
The items I ordered will allow me to adapt my utility trailer for transporting my sea kayaks. Curt and Hopkins are both quality manufacturers. On a shipping note, the box arrived at the Post Office broken wide open. Your shipping folks need to wrap small, heavy, items in bubble wrap. Then stabilize it with foam peanuts. Just putting it in a box then stuffing the box with craft paper does not cut it. Items were not damaged so I am good to go.
What our customers are saying:
"Very helpful/friendly Customer Service. Competitive Pricing. Shipping was Fast."