Trailer Brake Controller Specs:
Features:
...span>Automatic leveling lets you mount at any angle up and down for an easy installation Controller must be parallel with direction of travel and horizontally level Included harness hardwires to vehicle and plugs...
Installation Notes:
You need item ETBC7 ($129.19) to install your controller.
You may also need a 4-Flat connector to complete your wiring.
More Information >Code: C51170-C51515
Trailer Brake Controller Specs:
Features:
...Brake controller activates trailer brakes in proportion to your vehicle's braking action Automatically adjusts trailer's braking based on deceleration of tow vehicle Dash-mounted...
Installation Notes:
You need item ETBC7 ($129.19) to install your controller.
You may also need a 4-Flat connector to complete your wiring.
More Information >Trailer Brake Controller Specs:
Features:
...overheating by reducing power output during prolonged stops Continuous diagnostic checks alert you to any potential problems Automatic-leveling ability - internal sensor detects deceleration even if controller...
Installation Notes:
You need item ETBC7L ($114.65) to install your controller.
You may also need a 4-Flat connector to complete your wiring.
More Information >Trailer Brake Controller Specs:
Features:
...shorts Automatic leveling lets you mount at any angle up and down for an easy installation Controller must be parallel with direction of travel and horizontally level Mounting bracket and hardware included...
Installation Notes:
You need item ETBC7 ($129.19) to install your controller.
You may also need a 4-Flat connector to complete your wiring.
More Information >Trailer Brake Controller Specs:
Features:
...required to swap controller between vehicles Easy installation with automatic leveling Position anywhere from -90 degrees to 90 degrees up and down Controller must be parallel with direction of travel...
Installation Notes:
You need item ETBC7 ($129.19) to install your controller.
You may also need a 4-Flat connector to complete your wiring.
More Information >Trailer Brake Controller Specs:
Features:
...and easy installation with no mounting restrictions No need to mount level - install anywhere at any angle Mounting bracket and hardware included Plug-in, vehicle -specific brake control adapter (sold...
Installation Notes:
You need item ETBC7 ($129.19) to install your controller.
You may also need a 4-Flat connector to complete your wiring.
More Information >Trailer Brake Controller Specs:
Features:
...Brake controller activates trailer brakes in proportion to your vehicle's braking Automatically adjusts trailer's braking based on deceleration of tow vehicle User-controlled mode...
Installation Notes:
You need item ETBC7 ($129.19) to install your controller.
You may also need a 4-Flat connector to complete your wiring.
More Information >Videos
for Trailer Brake Controller
Help Articles
for Trailer Brake Controller
Expert Answers
for Trailer Brake Controller
A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…
view full answer...The correct replacement for a Demco Master Cylinder 05680-C is the Replacement Master Cylinder part #5650. I spoke with Demco to confirm this for you.
view full answer...The AL-KO trailer hub part number 8700 that you have is a 3,500 lb trailer hub/drum with a 5 on 4-1/2 inch bolt pattern. Based on that the #AKHD-545-35-EZ-K is the correct fit and would work great.
view full answer...The correct replacement master cylinder kit we have for your Demco setup is the part #DM5918 which comes with the lock out replacement.
view full answer...If your current springs have 5 leaves then going to a 7 leaf spring will increase the height of the trailer a little and make the trailer more susceptible to sway. Regarding capacity if you go with springs rated higher than what is required it will…
view full answer...I would be happy to help you set up your 2022 Toyota Highlander to haul your new travel trailer. The wiring harness you currently have controls your…
view full answer...I&…
view full answer...You will need the Red LED Trailer Clearance or Side Marker Light #328-K-52 or Amber LED Trailer Clearance or Side Marker Light #328-K-51 for your 2018 Forest River Sunseeker motorhome. These lenses have the same Top Command SAE-AP2-16 markings on…
view full answer...The 40 amp fuse for your 2006 Chevrolet Silverado tow package is used for the 12 volt battery charge circuit. This fuse is located toward the front of the underhood fuse box closest to the front auxiliary positive post (see photo). There may be a…
view full answer...On a 2005 Chevy Silverado 1500, If you are facing the front of the truck looking at the power distribution box, there will be a post at the back left side and a fuse slot near it. It is that fuse slot that you will install a 30 amp fuse. I have…
view full answer...The number you provided,…
view full answer...To tow your trailer that uses an RV style 7-way blade style connector with your semi that has a 7-pin connector, you need to construct an adapter that will also combine the brake signal into the right and left directional signal pins. This can be…
view full answer...Filter Products (14)
Contact and Help
What our customers are saying:
Excellent!! I ended up getting it the next day. Level of difficulty for installation should be a 3, not 5 - I had it installed in 20 minutes. Pricing, shipping, everything - a 10! Thanks.
Marc
Elmhurst, IL