Timbren Active Off-Road Bumpstops - Front Suspension - 1,800 lbs

Disappointed in this item TABSTOF. They look and feel almost exactly like the factory bump stops, except with a hole drilled in the center. I can't imagine these would make much of any difference in rebound cushioning as there is just not much to them. There is another part which is more appropriate TOFTAC4A, which are larger and would actually have a benefit whether in a standard or lifted suspension. 612558

by: Kevin08/05/2023

Easy install, work great. 1639633

by: Walberto natal08/25/2022

My 100 series 2001 Toyota Land cruiser uses four of these bump stops though the build quality of this product is excellent I am only giving it an average rating because 2 of the metal housing that the rubber sits in widens up at the bottom edge. I had to cut that edge back so that they would not scrape one on each side.1375711

by: Joseph 01/03/2024

1707340

by: Lynn 03/28/2021

996721

by: 2021 4Runner SR5 Premium09/23/2022

While towing my boat (2021 Tracker Pro Guide V-175/Mercury 115 ProXS, ~3,200lbs) in my 2021 Toyota 4Runner SR5 Premium, I noticed a significant rear squat. Additionally, fellow motorists would flag me for “high beaming” when I was not. This squatting in the rear raised the front end and subsequent headlight alignment. After much research and review, I purchased the Timbren SES and installed it. With the vehicle hitch unloaded, the SES rides approximately 1.250” above the rear axel. With the boat loaded onto the hitch, the Timbren SES contacts the axel and holds the load firmly, maintaining a level vehicle. I was pleasantly surprised to see that the ride was not greatly effected. Matter of fact, the vehicle rides much better while towing than before installing the SES. With the 3rd row seating in use, and the vehicle full of passengers, the rear passengers complained of a very bumpy ride and I noticed a very rough feel with hard bumps from the rear. After installing the Timbren SES, even with the boat on the hitch and the vehicle fully loaded, my 4Runner remains level and the ride is substantially improved. If you have 3rd row seating and/or plan on towing ANYTHING with your 4Runner, you absolutely need the Timbren SES. Installation is a breeze. Easiest accessory you’ll ever upgrade.1420941

Click to Enlarge

Can't wait to pull my RV trailer again and see less squat in the backend of my Raptor!! These are going to make a difference.1673437

Click to Enlarge

Ordered for my 2010 Toyota Tundra. Parts came quickly and had them installed in about 20 minutes. Just needed a good vehicle jack and impact wrench and was very easy. These have greatly reduced the sag when pulling my camper and very satisfied.1722490

Easy install, Nissan Xterra. Love that it came with all the hardware because I had to knock all existing hardware out with a hammer and chisel. I used four additional washers I had so I could put one inside the frame and one on the bumpstop mount. Etrailer shipped fast and free, bumpstops arrived ahead of schedule. Highly recommend these mounts, night and day difference.1337501

The factory bump stops were harsh. These engage sooner and while firm they do not crash like the OEM.
Easy install.1732134

Very easy to install, haven't traveled with trailer yet but will be traveling in April.1749825

These do what they're built to do. I overland a lot so when the truck gets weighed down with gear she tends to squat a little and when I go through bumpy areas the factory stops would slam the frame. No any more with these Active Bump Stops. A much smoother ride and less body roll when cornering.1308001

Click to Enlarge

Click to Enlarge

Click to View

Well after used the Chat online with Carol I ordered. Paid for 2 day shipping. Got it in 2 days.

Total install time 1 hour.1738152

Click to Enlarge

Click to Enlarge

Click to Enlarge

by: AMS03/02/2023

They seem to perform just fine, absorbing bumps and impacts etc. However they collect water like little buckets and the bolts are clearly corroding on the inside of the bumpstops since they have no drainage. Adding a way for water to escape faster than evaporation would be a good improvement to the product!1528955

by: Robert 02/21/2024

They work well towing a heavey trailer. 1736087

My 2013 4runner was squatting in the rear when I coupled my 6X12 motorcycle trailer. I was very happy to have found the Timbren bump stop to simply bolt on and fix the problem. However.....during the installation I noticed I had to use ALL of the adjustment slot on the unit to TRY to center on the rear axle. I oriented the units as far towards the rear as the adjustment would allow.
When I coupled my trailer to the 4runner it correctly forced the Timbren bump stop to contact the axle and this is where the problem is.
The Timbren bump stop CAN NOT be adjusted far enough towards the rear to accomplish a centering on the axle. There is a 25% overhang of the bump stop on the axle front. When I communicated with Timbren about this they said" it's a good installation and it's ok". It is not ok.
Imagine that all of the force of a fully loaded truck will be negotiating curves, potholes, swoops and other hazards of the road at highway speeds. All of this stress is distributed on 75% of the product. It can't work as well as if it was 100% distribution. I felt the product was overpriced to begin with. After paying a premium price I expected a custom proper fit.
I can't recommend this product for Toyota 4runner owners.
480449

Click to Enlarge

Click to Enlarge

I had these on my Tacoma and liked the way they worked so much that I got a set for my new to me Tundra. You don't notice anything until you put a load on the truck. Then you feel more stable under load and don't have to worry as much about the leaf springs. The install was done in 15 minutes718301

Click to Enlarge

Click to Enlarge

easy to install - might want to let installers know you don't need to remove rear tires or jack the vehicle up (safety first!) on the Tundra. Just remove the 3 oem 12mm bolts on each side and replace the itty-bitty oem bump stops with your nice Timbren's (17mm bolt head and nut).1650013

Installation was a breeze! Followed the instructions and lifted the truck up using a jack under my hitch, loosened the u-bolts, removed the factory bump stops and installed the timbrens! Took 5 minutes for each side, and 5 minutes to setup and take down setup. 15 minutes max. Very easy to do. I believe I am going to need a 1” spacer as I have 1.5” Icon add-a-leaf packs in order to get them to engage while towing.1097214

Click to Enlarge

Click to Enlarge

Click to Enlarge

by: Paul 10/31/2023

Work great, save my air bags from getting pinched if I let them get deflated.1688092

by: Jesus07/13/2022

I Install this product on the front and back of my 1994 toyota land cruiser ,I realy like them , we explore the Baja peninsula in MEXICO the off road land is very ruff , this bumpstop realy work . the don't crash in to my diferencial any more1326708

Click to Enlarge

Click to Enlarge

Click to Enlarge

I have had Timbrens on several trucks! I always thought they worked great! I plan on putting these on a new Tacoma, which I will not yet until the end of September so I hope they fit! They are a very good product otherwise I would not use them!1652252

I have a medium-duty truck and recently purchased a camp trailer. Well, when I pulled the trailer home for the first time the back of the truck was weighed down. I installed the new Timbren Active Off-Road Bumpstops and they improved the load capacity immensely. When I get the cash saved up I plan on purchasing the Timbren Active Off-Road Bumpstops for the front. Worth every penny. 762708

I had no problems with the installation. It only took about 15 minutes to put these on! There is adjustment space on the brackets to let u be able to center product over rear axles. The pictures below show the product installed while my 4 runner is both raised up for installation and after lowering it down. When lowered down and jack removed I have about an inch clearance. 820765

Click to Enlarge

Very effective upgrade and install wasn’t to bad either. Highly recommended! 2003 Toyota Tundra.1309490