Give your trailer a classic look and reliable protection. This rounded teardrop fender shields both tires on one side, keeping rocks, water, and road grime away from your cargo.
When replacing your trailer fender, do your best to match the dimensions of the new fender to your old one. If your fender was damaged in a blowout, you can use the opposite fender to get the right measurements. Before you get started, always chock your wheels for safety. If you are installing a bolt-on fender, use your existing mounting hardware if possible, but be prepared to replace any bolts or screws that are stripped or rusted. If you need to remove an old, welded-on fender, you can carefully chisel it off yourself or take your trailer to a weld shop for professional removal. Do not forget to prime and paint the new fender to prevent rust and match your trailer's finish. Before drilling any holes, position the fender exactly where you want it and center it over your wheel well, marking your spots carefully. Measure twice and drill once. Finally, wait to fully tighten down the mounting hardware until you are sure the fender is mounted just right.
Videos are provided as a guide only. Refer to manufacturer installation instructions and specs for complete information.
Hi everyone. Steve here with etrailer.com. Today we're looking at our tandem axle teardrop trailer fender for enclosed trailers with 14 to 15 inch wheels. Folks, this is quantity one. You're gonna get one with purchase and it's a rounded teardrop fender cover that's gonna cover two tires on your tandem axle trailer. As you know, fenders, they block road debris from hitting other vehicles.
They protect your trailer on your, or the cargo, on your trailer as well as long as other pedestrians. Now, you will need to prime and paint this before you install it. I recommend cleaning this one some kind of solvent because these do come with a light oil film on them that helps protect them until they get shipped out and used. So again, make sure you clean that off before you prime and paint it. It's a weld on or bolt-on application.
If you need to bolt it on, you will require drilling and maybe fabrication of some mounting brackets and the hardware to install does that is not included. Now some quick measurements. Overall, when I measured earlier, I got 66 inches long end to end, nine inches wide on the top width and from ground level to the top of the fender, I got 19 and one quarter inches tall. Again, folks, quantity one. That's gonna wrap it up for our look at this tandem axle, teardrop trailer fender.
I'm Steven, thanks for watching.
great quality fender, perfect fit.
left off a star due to no back plate is offered with this size, I had to cut out my own back plates.
So far they look great, I still needs to install. Great price with shipping. I searched high and low and these guys have what I need with a great price point.
Thanks, Scott
Great product, great service, shipped and received quickly
Fits well
Do you have a question about this Trailer Fender?
Info for this part was:
At etrailer.com we provide the best information available about the products we sell. We take the quality of our information seriously so that you can get the right part the first time. Let us know if anything is missing or if you have any questions.
Thank you! Your comment has been submitted successfully. You should be able to view your question/comment here within a few days.
Error submitting comment. Please try again momentarily.