When visibility matters, this 15-1/2" TecNiq low-profile ID bar delivers strong, consistent lighting across the back of your trailer. It’s powered by 3 bright LEDs that exceed FMVSS 108 standards, giving you the illumination you need for safe towing and clear signaling. Even with its slim 1-1/4" height, it produces wide, even light that helps other drivers see you clearly day or night.
If your trailer sees wet roads or regular washdowns, this light is ready. It’s hermetically sealed to the IP68 standard, keeping out dust and water completely. That means it’s fully submersible and won’t fog up or fail when exposed to moisture. The rugged design keeps the electronics protected so the light stays reliable season after season.
Durability is built in. The impact-resistant lens shields the LEDs from debris and rough use while holding up to vibration and movement. TecNiq backs it with a lifetime warranty for extra confidence. You can mount it once and count on it to last through years of hard service without cracking or fading.
This ID bar doesn’t get in the way or require complicated mounting. At only 1/2" deep, it keeps a sleek look against any flat surface. It mounts with two screws—caps included—for a tight, finished appearance. The built-in 9" wire lead makes connecting straightforward while keeping your setup neat and professional.
Videos are provided as a guide only. Refer to manufacturer installation instructions and specs for complete information.
Hi, everyone, Steven here with etrailer.com. Today we're looking at our TecNiq Low Profile for your over 80-inch ID Bar. It's 15 1/2 inches long with an nice red lens. So again, folks, if you have something that's over 80 inches wide, then you're gonna need this ID bar. It's powered by three bright LEDs. It's hermetic sealed for dust and waterproofing.
It's durable, impact-resistant lens is gonna keep everything protected. And again, this uses a nice pigtail here, I've got it pre-wired here just with a little demo box. Overall, 15 1/2 inches long. The mine holes will require two screws, sold separately. And this is gonna be 14 1/2 inches on center overall in the length.
And again, 1 1/4 inches tall, about 1/2 inch thick overall. And that's gonna wrap it up, folks. Again, an ID bar must be mounted up horizontally, just like you see here, that's per the state laws and regulations. So make sure you're checking all that out or reach out to us if you need any questions answered or if you need help with the product. I'm Steven, thanks for watching.
.
Customer Satisfaction Score:
99% were satisfied with this product
1% of customers were not satisfied
Ratings & Reviews
Bright
easy to install and looks nice
Info for this part was:
At etrailer we provide the best information available about the products we sell. We take the quality of our information seriously so that you can get the right part the first time. Let us know if anything is missing or if you have any questions.
Thank you! Your comment has been submitted successfully. You should be able to view your question/comment here within a few days.
Error submitting comment. Please try again momentarily.