To see if this custom-fit item will work for you please tell us what vehicle you'll use it with.
Thank you! Your comment has been submitted successfully. You should be able to view your question/comment here within a few days.
Error submitting comment. Please try again momentarily.
When you’re hauling gear or towing a trailer, rear-end sag can throw off steering, braking, and headlight aim. These SumoSprings Solo Custom Helper Springs add up to 1,500 lbs of support at 50-percent compression to keep your ride level and steady. The microcellular urethane material cushions bumps, absorbs shocks, and helps your factory suspension handle the extra weight without bottoming out.
Whether the bed’s empty or packed full, these springs adjust naturally to the weight you’re carrying. With light loads they compress easily for a softer ride, and with heavier loads they firm up—compressing as much as 80 percent—to give strong support. This progressive spring rate keeps driving smooth when unladen and stable when loaded so you can tow or haul without the jarring ride of stiffer setups.
When a curve or uneven load tries to push you around, each SumoSpring works on its own side to keep things balanced. That independent action helps reduce body roll and sway so your vehicle feels planted through turns, crosswinds, or when pulling into a sloped driveway. It’s a solid confidence boost when hauling on winding roads or busy highways.
Built from a closed-cell urethane that resists abrasion, oils, road salts, and UV rays, these springs hold up in real-world conditions from -25°F to 200°F. They compress vertically with minimal side expansion for a snug fit in tight spots and won’t get damaged by nearby parts. With no air lines to run or pressure to monitor, they’re completely maintenance-free once installed.
Adding suspension support doesn’t have to mean major garage time. The SumoSprings bolt right onto existing mounts with no drilling required. You’ll have a clean install that fits securely and gets you back on the road with better load control and comfort without any extra hassle.
Customer Satisfaction Score:
95% were satisfied with this product
5% of customers were not satisfied
Ratings & Reviews
The Sumo helper springs were not difficult to install (had to jack up the rear a few inches) & I really do think they have helped with steadiness in towing our camper.
Would recommend.
I have had these on my 2006 Colorado for a year, great product easy install I haul a compact tractor with bucket and tiller on a single axle trailer and the truck doesn't sag. No adverse ride quality when carrying no load definitely better than installing air shocks. Highly recommend to anyone having issues with vehicle sagging when loaded.
If you want an affordable, indestructible suspension upgrade to eliminate rear sag and towing harshness—without the maintenance head-aches of air systems—the SumoSprings Solo sourced through etrailer.com is one of the smartest weekend upgrades you can make. The installation was easy and the install video they provide on YouTube is priceless.
I’ve owned these SumoSprings for a year now and love them! I installed them on a 2016 Ram 1500 Crew Cab Outdoorsman 4x4. I tow a 7x14 aluminum cargo trailer that probably weighs 4000lbs loaded with gear. Before installing the SumoSprings my axles would almost touch my OEM bump stops and truck would sag. With SumoSprings my truck rides more evenly and is surprisingly smooth on the road. The ride quality is definitely better with SumoSprings. Less body roll in corners and an overall more confident ride. When I’m not towing I don’t even know they’re there. Awesome product!
Really solid for the money. Obviously if you plan to haul a load regularly you should upgrade springs or run bags, but these were a great temporary measure for hauling my bikes out west and back in my frontier. Easy to install and do the job well; particularly noticed the difference on rough dirt roads where in the past I would have been banging on the bump stops.
The Sumo Springs worked great in my 2022 Nissan Frontier and stopped the rear from sagging under trailer load but rode like normal unloaded. Very good product and very easy to install.
This only pertains to the order, shipping speed, and install as I have not put a heavy load on these sumo Springs yet but I feel like that's a foregone conclusion based off the reviews already. The ordering process, the shipping, and the installation was unbelievably easy. I kept rereading the instructions thinking this can't be right because it was so simple. I looked at the YouTube video and realized it is that simple! So happy with the ordering process, the quality of the initial product I opened, and how simple it was to put on the jeep.
I was surprised at how much of a difference these actually make. I bought them based on some videos of others using them, but wasn't sure if they would actually make much difference in my situation. I tow a 6800lb trailer with a Silverado 1500. With the tongue weight of that trailer, the rear of the truck doesn't drop all that much and I wasn't sure if replacing the bump stops was even necessary, but when I'm on roads with "heaves" and especially bridges where porpoising can be a problem, these SumoSpring certainly help. You probably won't notice some huge drastic change, but it's just enough to matter and even out the ride to a noticeable degree. Also, they're pretty easy to install (and I'm only barely handy when it comes to this stuff.)
I've never put on a easier product. I put the jack under the trailer hitch mount. Just lifted the body 1-2 inches and used a 12 mm socket . The socket removed the old ones and I hand tightened the new on. Literally took 10 minutes and a beer.
Great product! Bought these for my 2000 7.3 f250. Didn't want something that is constantly active like ras or hellwig since my leaf springs are new and rated for 4k pounds. Installed these in 1 hr super simple only hard part was the factory bump stop on driver side was a pain. Didn't install the puck they give due to height of truck and I knew more or less at what point I wanted them engaging. I haul cattle to shows/ auctions or between pastures with my 24ft big bend and these things actually provided a smoother ride in my truck loaded then unloaded.they do a great job with the added support and are better than an overload spring with handling sway and providing a smooth ride loaded. Just wish I could use the 3k pound rated ones on this truck and my dually but doesn't fit if you have a gooseneck sadly so will probably have to go with timbs on the drw. Over all great product can't speak to longevity but solid for the time being. And customer service with this company is excellent if you have a question or problem they're on top of it...hope they pay them as well as the reputation they're building for them.
I bought and installed the 1000lb Sumo Solo springs to help alleviate rear end squat on my 2024 GMC Canyon Denali when pulling my boat. My boat trailer has a long mono tongue with no weight distribution installed. The boat weighs in at about 5500lbs, the truck fender lip measures 38” high unloaded, once I dropped the hitch down on the ball and the Sumos picked up the load, the fenders measured 36.25” equating to an inch and 3/4 squat. Empty the Sumos have an apx gap of 7/8” above the frame rails. The Sumos were recommended over the Timbrens for my situation of infrequent towing with this truck and to maintain the best ride possible when not towing. So far my ride is virtually unchanged when empty and feels controlled when towing. Installation is straight forward but the instructions could be a little clearer with a diagram showing the intended location of the springs. Luckily an etrailer customer had already done the install and provided some pics so there was no question. I chose to remove the tires to have good access and I’d do it again this way. I supported the truck with a jack stand under the receiver. IMHO the proper method to locate the over frame upper clamp brackets is to push the forward clamp as far forward until it contacts the bed stiffener and you’ll be in the correct location then let all the hardware hang to position itself, tighten as required and enjoy.
Installed these right before a long road trip, and were impressed with how much the ride improved. Opted not to include the spacers, which has worked out fine. While not towing have not noticed any change to the ride, which is good. When towing the steering has a solid grip on the road now (sometimes felt a little loose before installing these) and no more issues with 'porpoising'. We drove across a several mile long bridge in the Bay Area that likely would have been a roller coaster ride previously, and had no issues. Quick and easy to install.
Put these on a Jeep Gladiator to haul a motorcycle to Sturgis. Kept everything level, good ride and stability. Highly recommend.
Product is great, exceeded my expectations. Install is simple and straightforward. It’s a night and day difference in both the body roll and the handling small bumps all the way up to off-road conditions.
I had installed this model SumoSpring on my 2019 4Runner and had great results when towing the camper I had at the time. They greatly reduce the bounce when going over dips in the road at highway speeds. Now I have a 2021 Titan and a bigger heavier camper. I expect the same great results on the Titan. Installation was pretty straight forward and took about a half hour. The size difference between the OEM bump stops and the SumoSprings alone should give a better ride when towing my camper.
Love them! The truck barely even squatted, had two dirt bikes, and a generator in the bed as well! It handles the bumps and sway great
I got the springs installed last week and wanted to have a drive time before I wrote the review.
The height of the springs are perfect for my 2016 Tacoma, They keep the truck stable and nearly eliminate the body roll I had before installing them. I am heading to the mountains in a couple weeks, so I will update the review when I get back. That way I will know for sure the body roll is gone and the truck is stable on the winding mountain roads.
The springs installed in no time at all and since I had the rear end apart, I decided to add the leveling blocks at the same time, to keep the truck from squatting with the gear I haul around with me.
The guys at etrailer are great. And while I did not call them to discuss this item, they have been very helpful in the past with all my questions.
Below are pictures of before, a couple comparisons and after. Sorry if they come out sideways.
These Sumo Springs were a great addition to my Tacoma and well worth the money, IMHO.
Opted for the Blue 1000lb Sumo's w/spacer over the 1500lb Black ones. 1500 Silverado Max Tow & reduces squatting by 2" on a 1000lb+ tongue weight. Ride is still good, but you can feel the Sumo's engage over large dips or bumps which is not an issue for me.
2025 Promaster 2500 159” wheelbase. Backed the van on couple 2” X 6 “ easier sliding under. Sprayed PB Blaster on top of bumper spring, using a 16” Channel Lock, easy off with the old. At that time I jacked the rear end to allow clearance. One side at a time. Took longer for set up then the job. I used the long bolt with two spacers. Have not drove yet, though looking for great results.
I put these on a 2013 Jeep JK (not lifted) that tows a 3000 lb trailer in rough terrain; Total game changer.
These replaced the anemic factory stops (which had completely disintegrated) and make it impossible to 'bottom out' on the dips and holes that use to beat up the suspension. I got nearly all of my vertical travel back and the vehicle now sits almost level under high tongue load.
They go on pretty easy. I suggest sliding in one side, and then using a wooden dowel and hammer to pop the other side in the stock receiver cup.
Highly recommended. These are a MUST if you are towing a trailer (with a medium sized SUV) of any significant weight or if you just want to be able to bounce hard without bottoming out your suspension. I am likely going to get the front suspension version now as well.
Wish I knew these existed sooner.
Awesome product. Installed in about 20m in.
The were very helpful on the phone help me get the right weight springs for my truck thank you!
Easy to install. Seem to work well. Haven’t really had the. Chance yet to give them a good test
First and foremost, etrailer provided excellent customer service throughout my experience trying to find the right SuperSprings support spring for my 23 GMC Canyon AT4X. In a nut shell there is a “for Gas engine” option (SSR-624-40 / SS57PV) and “for Diesel engine” option (SSR-216-47 / SS75FR). In my opinion the “for Diesel engine” option (SSR-216-47 / SS75FR) fits better on the Gas AT4X. Following the descriptions, I initially purchased the “for gas model” (SSR-624-40 / SS57PV), but while test fitting I noticed a “pinky” sized gap between the provided ubolt and the bottom of the axle (as seen in image). The lower shock mounting plate appeared to be the cause of this, which I can only assume is different on the AT4X than it is on the other models (shocks are outboard on the AT4X, and inboard on other models). I reached out for some guidance and SuperSprings suggested there was no problem with the gap. However, while waiting for their reply I had already decided to give the “for Diesel engine” model (SSR-216-47 / SS75FR) a try, which directly replaces the factory bump stop using factory hardware (no need to use the included brake line spacer on my application). This eliminated the ubolt gaps, and any concerns I had about reliability. etrailer returned my original purchase without any hassle. Whether my concerns were valid or not, I hope this review will save some time for other AT4X owners.
Info for this part was:
At etrailer we provide the best information available about the products we sell. We take the quality of our information seriously so that you can get the right part the first time.
Brooke M.
3/25/2025
I appreciate your explaining your experience with these and I'm happy to see you got them to work well for you. I think future readers will be grateful you took the time, too! :)