Thank you! Your comment has been submitted successfully. You should be able to view your question/comment here within a few days.
Error submitting comment. Please try again momentarily.
Replace a worn-out wiper seal on your RV slide out with a durable and longer-lasting upgrade. Best for replacing wipers that do not have an integrated bulb seal. Wiper sticks in place with adhesive backing for an easy DIY install.
Features:
Videos are provided as a guide only. Refer to manufacturer installation instructions and specs for complete information.
Hi there, I'm Michael with etrailer.com. Today we're gonna take a quick look at this RV slide out rubber wiper seal. This is gonna be a great option if you are needing to replace a seal on your RV slide out. And this will do a great job of helping to keep the water out of your RV, so you don't have to worry about mold and mildew and those sorts of things from water that are getting in there. And this is designed for use in RVs with separately installed bulb seals. So it is gonna be compatible with the rubber bulb seal that you see on the screen there.
And so if your original has a bulb seal similar to that one, this will do a great job. It's gonna flex in and out depending on the direction the slide out is moving. It is made here in the USA of a dense EPDM rubber. That is gonna hold up to your weather. It's not gonna shrink, crack, or fade over time, and it is gonna resist UV damage as well.
So it is gonna be very durable and long lasting. Definitely a higher quality than the original factory seal. So it is going to do a great job for you. It'll be a a good upgrade. Looking at our dimensions, this is right at four inches tall, about 4 1/16 of an inch tall, and you are going to get 30 feet of this here.
As you can see, it's all wound up on itself there. So that should be plenty to wrap around your slide out. You can use scissors to trim any extra seal once you're getting it installed. And it is a very simple installation. We've got the pre-installed 3M adhesive backing here, so we just peel off that backing and apply the seal to the RV frame surrounding your slide out.
It is suggested to do a little bit of surface preparation to remove any old adhesive and that sort of thing. But very simple to just peel back that backing, get it stuck in place and you're ready to go. So it is gonna be a great option if you are needing to replace original seal and it's gonna be a very simple upgrade for you. That completes our look for today. Again, I'm Michael with etrailer.com. Thanks for watching.
Ratings & Reviews
It went on just as described, I’m very satisfied with the ease of putting it on in very difficult confined spaces, great product!
sent it back did not work for my RV
Exact replacement. Arrived on time and the quality is better than the original.
Fast shipping
Just what I needed, fast delivery at a reasonable price
Great price fast shipping will definitely buy from this company again
I worked 6 hrs trying to install on 10' total bedroom slide, would not just press in used 2"x 6" board & hard rubber mallet, still rolled over & pulled out when putting slide in. Friend came to help spent another 3 hrs with 3/4" steel dowel and mallet to finally get seated in channel. put slide in, then out seal rolls over going in & only some comes out when putting slide out. Would not recommend this product to worst enemy.Now stuck with @25' extra.
wored well, easy install
Much better quality than original. Very good adhesive.
Saved $$$ DIY. If you have patience you can do it. A MUCH better product than was originally installed at the time purchased brand new. Creates a great seal. Allow a couple inches more for each slide out when ordering to allow for a good seal with a tad bit of overhang. Don’t want to see any daylight. Spraying a small amount of seal lubricant AND I DO MEAN SMALL on edge will help with it sliding. Too much and your hands can’t keep a grip. VERY GOOD PRODUCT.
Loved the support team. The wipe seal was perfect. Order shipped immediately. Already installed. Thank you!
So far so good. The Grand Design Image slide setup makes it a bit of a challenge to replace the “Tired” seals. It would be the same on whichever system is used. The sales are very close and offer very little room to work. Other than that I’m liking this design replacement. It’s still to early to be totally certain
Excellent customer service. I have ordered previously from etrailer amd the service and quality are the best.
The inside wiper seals all needed replace on our camper. They were the press in style. These were a little harder to install on the inside with much room to work with but I hope they will last longer.
Seal feels better than original,fit nice. Fast shipping.
I was told that this rubber seal was discontinued, but I found it at E trailer. He saved the day.
Can’t believe factory seal ripped after 5 years. This one seems a lot better. Fast delivery and good tracking. I have use them twice now. Next year I will probably do inside seal too.
This is a very hard to find size, and they had it. Haven't installed it yet, but the quality of the material looks very good.
Good product as it was advertised, staff assisted me in determine status of package when it did not make estimated delivery date. Satisfied, now will see how it fits…and performs.
Fast shipping. I needed this size wiper seal for the top side of my slide out openings. Good quality adhesive and top quality overall.
Great Product
Thank You
Do you have a question about this RV Slide Out Part?
Info for this part was:
At etrailer we provide the best information available about the products we sell. We take the quality of our information seriously so that you can get the right part the first time. Let us know if anything is missing or if you have any questions.
Brooke M.
11/26/2024
Thats great, Garrett! Please do come back and let us know how the install goes and how you like the seal.