Thank you! Your comment has been submitted successfully. You should be able to view your question/comment here within a few days.
Error submitting comment. Please try again momentarily.
3" Diameter waterproof utility light with chrome trim ring illuminates your trailer's interior with bright white light. Surface mount - hardware not included. 2-Wire pigtail.
Features:
Specs:
The waterproof construction of this light makes it ideal for use on trailers that may be submerged, like a boat trailer. The housing and lens are sonically sealed together to create a single unit, which means that water will not get into the light and damage the diodes or circuit board.
Lumens are used to measure the amount of usable light that is put out by a light source. Raw lumens represent the number of lumens that the manufacturer claims the LEDs are capable of producing. It does not include the light's drive method or the amount of light lost from the lens or reflector. Effective lumens take these factors into account and represent the number of lumens that are actually produced by the complete light assembly, not just the amount of light that the diodes are capable of producing. This light has a 224 raw lumen capacity and produces 168 effective lumens.
California residents: click here
The lights have worked great for backup lights on ranger boat trailer.
worked as expected, good over the counter light in galley.
Great LED light used to replace my backup lights on my bassboat trailer. I own a 2010 Ranger bassboat and I recently had a rear tandem tire blowout that damaged the right fiberglass fender. After getting the fender repaired I needed to replace the backup light (which of course was discontinued). I had to find a comparable replacement, so I inquired about the light at a Ranger dealership which retailed for $40.00ea!! I had read on a fishing forum that this etrailer light made a decent replacement for the discontinued light bulb. This light is much brighter than the original, so I replaced both. This fixture is listed as submersible (have not put the boat in the water yet).
CON: This light fixture is about 1/8" smaller in diameter than the OEM fixture (photo), But it is easy to compensate with a small stainless bolt and washer to snug up against the existing hole in the fender. The plastic chrome trim covered any space or holes. I had no problem finding stainless flathead hardware at my local hardware store.
I looked everywhere for a replacement 3” diameter back up light for my Ranger boat trailer. No luck. Ranger didn’t even have a suitable replacement.
That was until I found etrailer.com. Not only did they have what I thought I needed, they answered all of my questions which lead me to my decision to purchase them. After a lot of prep work, I finally installed them yesterday with great success. Not only was the product excellent, but the service was the best I’ve ever had. They kept me informed for every step of the shipping process. Never been treated like that before. Thank you etrailer!
One last note to Ranger Boat trailer owners, I made a 3” dia. x ½” long aluminum adaptor. I mounted the adaptor to the trailer using the 3 existing holes from the original light, and tapping 2 hole for the new UCL60CB. Works great!
2009 Z520 Ranger...with some modifications they fit great. It was a plus that I work in a machine shop.I has to open up the hole in the stainless steel cover plate, put the new light in the cover plate and drilled the 3 holes in the light...fit perfect!!
Katrina D.
10/6/2023
Your installation worked out well it seems! Lookin' good!
Have a 2006 Z20 Ranger Bassboat that my original lights finally gave out. I ordered these as a replacement. They were very easy to install! Make sure to order the wire harness that is "suggested" when ordering. Would have saved me a few days but totally my fault. Also replaced my reverse lights. Both lights are very bright and Im certain will have years more of use. Have suggested the same lights countless times on various Ranger forums and everyone is very pleased as I am with the end result. Thanks again etrailer for a quality product!
Installed them on my 2008 Ranger Trail trailer reverse tail light! Had to do some modifications to the old 3 screw mounting brackets so I didn’t make new holes as this light come with only two screw holes. Made the old 3 screw mounting bracket fit over the LED lights! Extended the wires as well and a new ground! Installed them and it turned out great for replacement lights!
Read a review from Kevin C. about them fitting his Ranger boat trailer. He was right. My '09 trailer needed upgrade to LED for early morning launches. Lights mounted in existing hole. Needed little nut/bolt with larger washers to hold secure. Even though trim is plastic chrome, it still looks good. Have not used lights in real situation but in garage they seem to be about as bright as old lights, however, it seems to light a larger area. A little on the blue tint side. Hope they are truly submersible.
really bright, hoping they are water proof like they said they are. I put them on in very short time and will try them out tomorrow to see
Very nice bright interior RV light, I placed it above the kitchen cabinet top work area!!! Additionally, I upgraded all my interior lights to LEDs in my Renegade Toterhome!
I had to do some Jerry rigging but they look amazing
I have a 2009 Z520 Ranger Commanche, these lights work great on my trailer,great price, took about 5 minutes per light to install, holes didn't match perfect, but no worries, a small drill bit, done!
Didn’t work! Returned
great product for Rangertrail trailer especially older models that no longer can purchase halogen backup lights as replacements
always great service
I used these as back-up lights on a trailer. They are sealed, flat, and VERY bright. They work great for this nonstandard application. If used inside, keep in mind they will light up the whole space and you don't want to look directly at them
Awesome product,
Used as headlamps for this 2007 Kawasaki KFX90
Perfect size for this application and low current draw , will not affect any other systems on the bike, looks mean!
Thanks George!
GREAT SERRVICE
I used all of the items in a van conversion and they have worked out great, I've attached photos.
Thanks for the follow up!!!
Easy to install and work perfectly
Easy installation
Look like what I wanted but wish they would q have cane with screws
My order arrived promptly and as ordered. I will continue to use etrailer for future purchases.
Do you have a question about this RV Exterior Light?
Info for this part was:
At etrailer.com we provide the best information available about the products we sell. We take the quality of our information seriously so that you can get the right part the first time. Let us know if anything is missing or if you have any questions.
Rusty B.
3/8/2025
1 year later still working great, after being submerged in salt water numerous times! Looks better than original light!