How Does LED Utility Light # UCL60CB Normally Wire to Trailer
Published 08/16/2018 >
Question:
Hello! I have an enclosed cargo trailer that I wanted to add lighting to on the inside. How do you recommend these being tied into the various circuits? Could you send me a wiring diagram if you have one available?
asked by: Chris B
Expert Reply:
Basically the LED Utility Light # UCL60CB that you referenced only needs 12 volt power ran to the red wire and then ground on the white wire. Typically people will run the power wire from the 12 volt accessory circuit on the trailer. This commonly is ran to a battery if availalble. Then for the ground you can attach it to a metal part of the trailer frame or run it back to the ground of the trailer battery.
Product Page this Question was Asked From
Optronics LED RV Utility Light - Submersible - 168 Lumens - Round - Chrome Trim - Clear Lens
- RV Exterior Lights
- Utility Light
- Hardwired
- Surface Mount
- LED Light
- 12V
- Chrome
- Optronics
more information >
Continue Researching
- Q&A: Replacement Reverse Light for Ranger z521 Boat Trailer
- Q&A: Replacement Lights for RV With Lights Taking Water Damage
- Q&A: Cross Reference for Kodiak Ceramic Brake Pads # K2250CP
- Q&A: Do Lippert ABS Electric 12" Brake Assemblies Come Pre-Adjusted, Or Do I Manually Adjust Them First?
- Q&A: Will The New Replacement Command Center Hub for Curt RVi Series 4 Work on a Series 3
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Q&A: Replacement Marker/Clearance Lights For a 2006 Ranger Trail Boat Trailer
- Q&A: Replacement Motor For The Atwood 75721 Electric Landing Gear Motor
- Article: What are the Common Types of Propane Fittings Used on RVs?
- Article: 30-Amp and 50-Amp RV Service: What's the Difference?
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: The 5 Best Trailer Drop Hitches You Can Buy
- Article: Brake Controller Installation: Starting from Scratch
- Article: 5 Reasons to Convert Your RV Lights to LEDs Today

