Looking for 2-1/2 to 3 Inch Clear Round Trailer Light
Updated 02/12/2016 | Published 02/11/2016
Products Featured in This Question
Question:
Hello I am looking for a clear round lense about 2.5-3 inches in diameter. Do they make such a thing?
asked by: Mike P
0
Expert Reply:
It depends on what type of light you are looking for. If you want a tail light assembly then it would have to have a red reflector on it to be DOT approved. If you are looking for a utility light (white light) then we do have some available, # UCL60CB or # UCL50CB.
As far as just a lens we have some clear ones but they are over 4 inches in diameter.
expert reply by:
Michael H
0
Product Page this Question was Asked From
Optronics Trailer Tail Light - Stop, Turn, Tail - Incandescent - Round - Red Lens
- Trailer Lights
- Tail Lights
- Brake/Tail/Turn
- Round
- Recessed Mount
- Non-Submersible Lights
- Incandescent Light
- 5-3/8 Inch Diameter
- Red
- Optronics
more information >
Continue Researching
- Q&A: Replacement Wheel Similar To Lionshead Bobcat
- Q&A: Replacement Hub With LM48548 Inner Bearing And L44649 Outer Bearing
- Q&A: Recommended Tail Lights For 4" Round Hole on Stock Trailer
- Article: Pintle-Hitches
- Article: Glacier Chains
- Q&A: Wiring Instructions for Optronics 4-1/2 Inch Round Trailer Stop Turn and Tail Light # ST40RB
- Q&A: What Hole Size is Needed for Flush Mount of Peterson # 435800 Sealed Tail Light
- Q&A: 4 Inch Round Trailer Tail Light Cutout Size
- Q&A: Troubleshooting Dexter Electric Over Hydraulic Brake Actuator Pump that Runs But Brakes Do Not Work
- Article: Performance Chips and Modules
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: 5 Reasons to Convert Your RV Lights to LEDs Today
- Article: Converting Your RV Water Heater to Tankless
- Article: How to Tell the Weight Rating of a Trailer Axle