Thank you! Your comment has been submitted successfully. You should be able to view your question/comment here within a few days.
Error submitting comment. Please try again momentarily.
Perhaps the easiest light kit to install, the sealed light units snap into the built-in mounting brackets on Draw-Tite, Rola and Tow Ready cargo carriers and then plug into the existing 4-pole trailer connector on the vehicle.
Features:
Light Kit Installation
Step 1
Mount rubber grommets on both sides of cargo carrier tray making sure grommets are seated securely.
Step 2
Press tail lamps into grommets until seated securely on both sides of carrier tray.
Step 3
Route plug with green wire under cargo carrier to the passenger side (right) and plug into cargo carrier tail lamp.
Route plug with yellow wire under cargo carrier to the driver side (left) and plug into cargo carrier tail lamp.
Step 4
With supplied cable ties, secure all wiring to the bottom of the cargo carrier.
Please note: With the off-set Y-harness, one wire lead (about 3' long) is run straight to a light, the other lead (about 6' long) is run along the back edge of the carrier before it curves up to the second light. On the 40101 and 59502 cargo carriers, the wires come up through the carriers' mesh floor to attach to the back of the lights. On the Tow Ready carriers 63153 and 63155, the tighter mesh floor is not large enough for the plug to pass through. Therefore run the wire leads under the platform to the lights, then up the front of the carrier and around to the back of the light. This also helps prevent the wires from getting pinched by the cargo. On vehicles where the 4-pole trailer connector is tucked under the vehicle, a 4-pole extension may be required to connect the two plugs. See 'related items.'
Customer Satisfaction Score:
98% were satisfied with this product
2% of customers were not satisfied
Ratings & Reviews
Robert J.
6/12/2014
I am very pleased with this unit and use it all summer long. Great Idea....
Willie L.
6/12/2014
The carrier and light hook-up are very good. I have used them often. I would highly recommend them. God bless!!!
Heather A.
5/24/2023
I can imagine that is annoying Stephanie. I have heard of this issue before and other customers use silicone to secure the gaskets into the cut outs.
Benny
6/3/2020
Still working great. Great product an service from etrailer as usual
Terry H.
5/15/2013
I agree that the lights fit too loosely. I now have one light because a cooler slid and popped the other light out while driving. Thanks to the quick connectdisconnect feature, the light is along the road somewhere.
Patrick B.
5/15/2013
Jim C.
4/16/2015
One year update: Were still using it on the back of our 5th wheel to carry a diamond plate tool box. Its working out quite well. The supplied hardware started rusting within the first few weeks. Other than that...all is well.
Jim B.
5/27/2013
I just made a 2013 purchase and it is disappointing that ETrailer hasnt fixed this issue 6 years later.
Patrick B.
5/28/2013
Do you have a question about this Accessories and Part?
Info for this part was:
At etrailer we provide the best information available about the products we sell. We take the quality of our information seriously so that you can get the right part the first time. Let us know if anything is missing or if you have any questions.
Freddie R.
7/22/2015
No problems. The only thing I would change is to make the wires for the lights longer so they could be attached along the perimeter of the frame instead of jutting across.