Most Popular Hitch Bike Racks for 2021 Ram 2500

I use the bike rack on the back of my fifth wheel. I have a hitch installed on my camper & I recommend this product.

Haven't used it yet, have to put together yet. looks okay

Unbelievably quick turnaround from order to delivery. The products ordered were exactly what I ordered and no issues with the packing materials.

I've been looking a eBike racks for about a month and finally decided on this Swagman rack because it's rated for use on an RV. That's what I needed because it will be on the back of my travel trailer. I had it on my wish list on another site but etrailer had it for $[XX] less, so I jumped on it. It was fairly easy to put together, I installed it on the hitch on my truck so I wouldn't have to wrestle with it on the floor of my garage, that made it easy to assemble. This rack is very well built, and is very solid, it doesn't move while on the hitch on my truck (I installed the RV hardware) so I have no doubt that in will be fine on the back of mhy travel trailer.

The straps are junk and four of them tore within a week of using them. I also almost lost one bike because of the straps. If I could I would return this unit.

We used this bike rack for at least 2 RV trips. The third trip we took we lost one bike off of the rear most rack. Ended up having to replace this bike rack with one from another store. Would only recommend for local trips only.

Super easy to load 4 bikes and go. Takes me 5 minutes to get all 4 on the rack, compared to 15-20 with the rack I had before. I would change nothing honestly. It's a fantastic rack. It has performed great. I can now quickly load 2 kids bikes and 2 adult bikes on the rack with no special adapters. We can hit trails faster and spend more time riding. There is no real downside. It's also significantly cheaper than competitors and provides a much easier and smooth experience. Is it a great rack for small families who want to ride together. No adapters needed for different sized bikes and super easy to load and unload. I would not recommend this particular model if you don't plan on using more than 2 slots. But for 3 or 4 it rules.

One year in and it is great. I have a 2021 Subaru accent and it is perfect. We carry 4 adult bikes and while it is a tight fit it works great. The rack is VERY solid and does not move when tightened up. Over the past year we have used it 3-4 times with no issues so far. It is easy to use and one person can easily load and unload the bikes. The tilt up feature is nice and when the rack is down and there are no bikes we can open the back hatch without an issue and there is plenty of clearance. We have been very happy with the performance and the price.

This is a really good rack. We do a lot of car camping out of our Subaru Outback and I wanted a bike rack that would swing aside so we can raise the hatchback and easily access the camping gear, cooler, duffel bags, etc that we carry in back (see photo). This rack 100% solves that problem. Further, the bike hold-downs are very secure. I use them on their own for shorter trips. For a longer trip or one that may involve a rough road, I supplement them with a ratchet strap, but this is probably just unnecessary paranoia--the hold-downs are excellent. My one heads-up about this rack is that it is heavy. I am a large, strong man and can attach it myself, but I do not look forward to the chore. This is a beefy rack and the weight is unavoidable. I welcome how sturdily-built the rack is. We typically carry my normal bike and my wife's heavy e-bike on it, and the rack is totally up to the job. Highly recommended. I have zero regrets about the purchase and the investment in this rack that will serve us for many years to come. The design is pretty much perfect--I can't think of one thing I would change.

We love our RockyMounts BackStage Bike Rack. The fact that it can hold our two e-bikes and swings out for rear door access makes it perfect for vanlife. Service and communication from etrailer is outstanading!

This rack is heavy, easy to assemble and has zero wobble. The reason I purchased this rack was due to the quality of the rack, but also my last experience with trailer. Great customer service, and if you have a question, it's pretty easy to get hold of a real person! I actually purchased this for an Ebike.

Works for my fat tire bike. Once it's set up, it's easy to install and remove. I had to cut out some of the plastic cladding on the underside of my bumper on my 2014 Subaru Outback. Good value. I've had no issues.

GI love the Rack, it is easy for me to handle, (as a 89 yearold rider.), two bikes ride and fit very nicely. Like how it folds down,and how it folds to open the tailgate . Great quality for the money, I would highly recommend this rack

I was sent additional mounting materials that don't correspond with my hitch or my bike rack. See the photo below. Are these materials for my Swagman STC2 Bike Rack Item #S64670?

Very stable and simple to use bike rack that works great with my road bike AND with my 29" Big Rippers. It makes loading and unloading the bikes a snap and they are safe and secure for traveling once loaded and secured. I have already logged over a thousand miles hauling bicycles with this rack and highly recommend it. I am a big fan of Yakima roof racks but, honestly, wish I would have went with this setup for my bikes from the beginning.

I have had my Kuat NV 2.0 4-Bike Platform Rack - 2" Hitches - Tilting - Metallic Black for a month now. Amazing engineering. Solid rack. I have four or five old (cheaper) racks and this is the best rack I have ever seen by far. Extremely happy with this. I will reserve comment on whether or not a bike rack should cost $xx.xx but it’s a great rack. Possible improvements: 1) The rack is just too heavy. With the amazing engineers that worked on this, knocking 10 lbs off the rack would be easy. I know it is one of the lighter ones available but it is still too heavy. The center rail is all steel and the heaviest part. The outer part of the swing arms are steel (inner part is aluminum). The arms have really nice bushings on the hinges. The whole thing is amazing, well-built, and well-engineered. IDEA 1: lightweight the center rail by using U-lube instead of square tube. Or just make holes through the top and bottom of he square rail. IDEA 2) The Aluminum platforms are amazing. But use less Al and more plastic. The ones for the back tire add significant weight. 2) Someone came up with a great idea for dealing with one aspect of the weight problem. One problem is that at 54 lbs. when you put it in the receiver it’s hard to align the hitch pin hole by yourself. So I kludged up a stop using a ring clamp and some plastic tubing. I was going to tap a hole in the center rail for a stop screw but then I could not adjust the depth for different vehicles. So I went with the ring clamp. When installing it (see photo) I noticed that someone already had a great idea and tapped a hole to add a stop. I assume there is an adjustable clip that is secured by the recessed screw. But I did not receive the clip. I just have a beautifully designed tapped hole and recessed screw with no way to use it. Probably an easy answer to this one but i didn't get a clip and didn't see this referenced in the instructions at all. 3) Back tire surface. It almost doesn’t matter where you ride the mountain bike, somewhere along the trial there is sandy, gravely surface that gets on your tires. I have gone in five ‘dirt’ trails and covered my tires with smooth mud thinking that I wasn’t going to hit sand. Then when I get back to the parking lot the mud collects the sandy gravel—either in the gravel parking lot or at the edge of the asphalt lot. Then I put the bike on the beautiful smooth aluminum carrier and scratch it. There should be an improvement to resurface the area where the back tire goes. It looks like there has been some weak attempt to provide a plastic coat but it doesn’t work. I am going to buy some rubberized truck-bed liner or spray rubberized spray rust proofer to refinish this. 4) Last possible improvement. The only people that should be buying this bike rack are people with high end mountain bikes. The reason for the platform carrier is to accommodate the odd frame geometry of mountain bikes and to protect the full suspension from dangling and getting air in the cylinders. If you have a full carbon road bike then just hang it on the back of your car with a $200 bike rack. And no one is going to carry $120 steel Walmart BLO’s with a $xx.xx platform carrier. They are going to strap them to the roof of their minivan. So you could even make this carry less weight capacity to make it lighter. And just tell people to put the 60 lb bike (like ebikes) closest to vehicle and lighter bikes in the back. EVERYONE has a lighter bike… either aluminum, carbon, or just a kids bike. This rack can carry 250 lbs of bikes (4 x 60+). The market for carrying 250lbs of bikes is nearly zero. delivery was perfect. Assembly was easy with two people; probably could do it with one. As you can tell, it is a real stretch to find anything wrong with this. But my minor comments are above.

This product arrived quickly, in good condition, and all steps were well-communicated by etrailers.com. This product seems pretty well-made and I added a Kuat Pivot to assist with swinging our 4 bikes out of the way. Very well thought out products overall and we look forward to using it for years to come with our travels. Wish we knew that that Nv 2.0 and nv 2.0 add-on each came with a child bike adapter. I had separately ordered 2 from Kuat for my kids and had to eat the shipping costs on the whole return.

Seems like a good rack for the price, especially when compared to others with the same weight rating. It was very easy to assemble, just a few bolts and that's it. I put two 62lb e-bikes on it (Ride1Up Turris) and it has minimal wobble and movement as expected. The straps that come on the center cradles were too short to go around our bike's frame and battery so I had to purchase a separate set of long straps from Saris for an additional $20. So be aware if you have an e-bike with a fat frame where you plan to use the cradle on, you might have to spend another $20 on a pair of long straps. While I waited for the straps I just used a velcro-strap and it worked fine. So far I am content with this rack overall and hope it lasts many years.. I gave it 4 stars instead of 5 because I had to purchase additional straps to make it work.

I had to put my electric bikes into this rack, backwards, to make them fit. Not ideal, but it works.The receiving 'trays' that are intended to provide support for holding the bikes, by being placed under the bike tires, are forced to be moved to a location that is not directly under the bottom of the bike tires. While it works in this manner, it is not ideal.For the support that attaches to the diagonal bike frame, we had to remove it from the vertical rail of the rack. We reinstalled it, upside down, because that's the only way we could make it fit, or 'grab', the bike frame. Again, we made it work, but it's not ideal. We chose to keep the rack because it was so much less expensive than the Thule rack we considered buying. The bike shop owner didn't agree with us. He observed that we are putting $3000 worth of bikes on the rack and risking that investment. So far, no problems, other than the ill-fitting installation.

This bike rack is awesome. Our two e-mountain bikes fit perfectly on the rack. We have taken them on long road trips with no issues. Great bike rack.

Great sturdy rack, and the wheels are very beneficial. Have never been a fan of the Thule locks, but the rack makes up for it.

After much searching, I decided to purchase the Kuat NV 2.0. I was fairly easy to put together….” Read the directions “ it will tell you exactly what and how to put it together.. Great instructions easy to follow. I was able to adjust the wheel cradle to fit my bike quickly. I was a SMALL problem…. I did not get any information from etrailer like I have in the passed… which was strange. So I did not know if they were processing my purchase or not… The money came out of my account. So I after my bike rack showed up… I sent a text to them, with in minutes I received at response, that said they were looking into the problem.. maybe 20 mins later I got a response from them … It seems I Fat Fingered my 1 letter on my e-mail address so etrailer could not send tracking information… Thank you so much GREAT SERVICE. I will use them again

Product was pretty easy to assemble. If assembled it solo, and it was a bit tricky keep the trays level as I bolted them to the center beam. I used the foam blocks that came with the packaging to keep them level as I tightened the bolts. The product looks fantastic in gloss black (matches my trim). Have not mounted the bikes yet (it's winter) though I did mount the rack in the hitch and took a test drive ... all good.