Longer Ball Mount that Fits 1-1/4 inch Trailer Hitch

Published 11/22/2022

Products Featured in This Question

Curt Trailer Hitch Receiver - Custom Fit - Class II - 1-1/4"

(21)

$224.37

Curt Class II Drawbar - 3/4" Rise, 1-1/4" Drop - 9-3/4" Long - 3,500 lbs

(2256)

$28.60

Question:

Jameson While it has been hard to fine a very level surface to check the hitch receiver height measurement at this time it appears the closest drop measurement available that at least comes close to the actual measurements from top of receiver to bottom of coupler is going to be a 1.25” drop ball mount. Can you suggest based on that which Curt 1.25” ball mount will be the longest to meet that requirement? I believe from looking on Curt’s website this might be the one that is longest with the expectected required drop. #45519

asked by: Dave

Expert Reply:

A longer ball mount would be a decent idea I would think but since its going to be a Class II 1-1/4 inch ball there aren't super long options. Mostly everything will be about same length with some variations. If you can determine the rise/drop you need I can let you know what longest option would be.

expert reply by: Jameson C

Boat Trailer
(click to enlarge)

Dave

11/22/2022

Jameson C.

11/22/2022

The Curt ball mount part # C45519 would definitely be your best option. This has the 1-1/4 inch drop you need and is longer at 9-3/4 inches from the center of the hitch pin hole to the ball mount hole center so it would be best option.