Installation Instructions for Lippert LC675817 Ground Control 3.0 Electric RV Leveling System

Question

Question:

Is there a manual for installing the lippert 3.0 leveling system

asked by: Gary B

0

Expert Reply:

There sure is! If you use the provided links, you can see both the owner's manual which shows how to use the system as well as the installation instructions.

I'll also link to a video showing a typical installation, which you might find helpful.

expert reply by: Mike L

0

Answer 1

We do not carry the Innoflame line of RV fireplaces. However, I do have other potential options for you depending on the size of fireplace that you have. I have also listed the wall cut-out dimensions for each fireplace, so that you can determine…

view full answer...

Answer 2

If you are experiencing the fifth wheel bouncing around when you are parked even with the king pin stabilizer like part #UF19-950500 and wheel stabilizers like part #UF21-001070 you do have a couple more options to stabilize the fifth wheel. I…

view full answer...

Answer 3

For your toy hauler patio door I recommend using some drop leg stabilizer jacks like the Stallion Stabilizer Jacks #288-01892-2. These jacks have a retracted height of 15-1/4" and extended height of 22-1/4" and a combined weight capacity of…

view full answer...

Answer 4

I have included a picture showing how the motor and switch wire up on the Lippert stabilizer jack #LC298707.

view full answer...

Answer 5

Thanks for reaching out, Randy. We do offer the Lippert TT leveling system, however I was not able to find any references for the part number 811995 you provided. If you are looking to replace the tongue jack portion of your Lippert TT system, the…

view full answer...

Answer 6

If you're looking for the hard plastic piece that covers the manual override on your Lippert Smart Jack Electric Trailer Jack #LC643589, you can use part #LC733925. Aside from that and the drop leg #LC405217, Lippert does not offer any other…

view full answer...

Answer 7

I have a complete replacement jack option for you, but the buttons on your Lippert Smart Jack #LC643589 are not replaceable so the only option is a complete replacement. If your jack is still within the 1-year warranty period then I recommend…

view full answer...

Answer 8

To replace your TDE Model LP7000 actuator, I recommend the Dexter DX7.5L A-60 Brake Actuator w Electric Lockout item #DX89FR. This coupler is designed to mount on top of a standard 3" wide trailer tongue. It measures right at 3-3/8" wide so…

view full answer...

Answer 9

Trailer tires should be inflated when they are cold and should be inflated to the max psi rating on the sidewall. In your case you would want to run 80 psi. If you don't inflate them to the max psi figure you will lose weight capacity and…

view full answer...

Answer 10

You will want to use a minimum of 10 gauge wire like #10-1-1 from the battery to the motor on the Lippert High-Speed Power Stabilizer Jack #LC298707. I do not recommend running a front and rear stabilizer to the same power wire. Each wire uses a…

view full answer...

Answer 11

We can get your stabilizer set up, and I can tell you where each of the four wires go for the Ultra-Fab Power Twin II Electric Stabilizer with Dual Motors #UF39-941705. I have added a cut out for you of the installation instructions which cover how…

view full answer...

Answer 12

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Installation Instructions for Lippert LC675817 Ground Control 3.0 Electric RV Leveling System

Product Page this Question was Asked From

Featured Help Information

Instructions

Miscellaneous Media

Continue Researching